Front Cross Member Bolts?

[Blurred Talon]

I need to get new bolts for my front cross member (holds the motor mount). I've got all the bolts and bushings that bolt to the front rad support but need to get the ones at the back.

According to ASA there's 3, 1 is a 10x22, another is 10x75 and the last is 10x45. They've all got washers on them.
Now I know that 10 is 10mm size, 22 is the lenght, what thread pitch would they be? 1.25 or 1.50? Also 2 of the bolts have 10T listed in the part spec, what does this mean?

Here's the part numbers:
10x22 - MU240137
10x75 - MU240025
10x45 - MU240024

Thanks guys!

 

[19Eclipse90]

1.25 mm pitch.

I do not know what the 10T or 7T or 4T notations that appear in ASA are meant to indicate.

 

[dalesmitsu]

Check this out bro. This could help, I'm planning to replace mine when I put in a new radiator support (either weld lower tie bar like you did or buy it new ).

jnztuning.com supporting vendor. Type in 1996 eclipse from catagory on left side click on Engine/Transaxle, and then Engine C'member. They have all the components for the cross member.

jnztuning.com copy/paste part number in Part number search
MU240137 $3.29
MU240025 $2.48
MU240024 $2.26

They're the same for the 1996 Eclipse. Picture is to show they have the whole thing.

 

[SpiderGST]

Does anyone make a solid bar with solid bushings for the 2g GST?

 

[Blurred Talon]

Check this out bro. This could help, I'm planning to replace mine when I put in a new radiator support (either weld lower tie bar like you did or buy it new ).

jnztuning.com supporting vendor. Type in 1996 eclipse from catagory on left side click on Engine/Transaxle, and then Engine C'member. They have all the components for the cross member.

jnztuning.com copy/paste part number in Part number search
MU240137 $3.29
MU240025 $2.48
MU240024 $2.26

They're the same for the 1996 Eclipse. Picture is to show they have the whole thing.

I have the front hardware, it's the rear stuff I need. I've tried to find the bolts at the hardware store today but no luck.

Does anyone make a solid bar with solid bushings for the 2g GST?

Frontline Fab has a prototype one.

 

[b00st3d]

Did you ever find out the size for the bolts that go into the subframe?

 

[19Eclipse90]

Did you ever find out the size for the bolts that go into the subframe?

You might give this a once over: Suspension Bolt/nut sizes.