Specs & Mods
- Ownership Status
- Currently Own
- Year
- 1997
- Model/Trim
- Mitsubishi Eclipse GSX
- Turbo Type
- GT40 Variant
- Drivetrain
- AWD
- Transmission Type
- Manual
- Build Type
- Road Course
- Mods-Bolt-on
- HKS Carbon Ti exhaust
Custom Vband downpipe
Slow boy race FMIC
Custom short route IC piping
Old skool Greddy type S
JM fab forward facing manifold
Tial 38mm external wastegate
Holset HX40
Turbo smart MBC
Custom catch can
EVO 3 intake mani
1g NT throttle body
Honda half rad
FAL 12” rad fan
Corbeau A4 seats and rails
Sparco steering wheel
NRG hub and quick release
PTP turbo blanket
- Mods-Engine
- Built 6 bolt .020 over
MLS cometic head gasket
Manley platinum pistons
Manley H beam rods
ACL race rod bearings
ACL race crank bearings
ARP hardware throughout
-12AN oil feed
-4AN oil return
Built 2g head
L19 head studs
BC 272 cams
Kiggly retainers
Titanium valves
Kiggly HLA
Upgraded lifters
eBay catch can
-10 fittings and lines on valve cover
Custom 12 gallon fuel cell
Custom fuel cell cage tied into frame of car
Custom dual 380 AEM pumps and filters
STM post e85 filter
PTE 1600cc injectors
Old skool aeromotive FPR
-6 AN return line
-10 to -6 AN feed line from pumps to rail
Radium fuel sending unit (0-90 ohms)
- Mods-EMS & Logging
- DSMlink V3
Cobalt gauges (boost, oil pressure, oil temp, water temp, fuel level)
Innovative wideband
Innovative ethanol content sensor & gauge
Speed density setup
- Mods-Drivetrain
- TRE built stage 3.5
TRE built transfer case
TRD LSD EVO rear differential
ACT 2600 pressure plate
ACT six puck clutch disk
ACT street lite flywheel
ARP flywheel bolts
- Mods-Handling
- Silvers coilovers with swift springs
TCE performance 14” front wilwood big brake kit (6 pot calipers, stainless lines, street/track pads)
EVO 8 rear brembos
Solid K member bushings (Paul volk)
All new front end control arms and bushings (moog problem solver equipment)
Paul Volk tear tubular subframe
PV rear adjustable control arms
PV rear adjustable toe arms
PV rear adjustable trailing arms
ST front and rear sway bars
17x8 +35 XXR 531 with 235/40/17 nitto NT01 for the street
17x8 +30 cosmis XT with 245/40/17 falken azenis rt615 for the track
Carbon hood
- Parts Wishlist
- Full compliant cage, fire suppression, better coilovers, better rear brake setup, FP red, anything that can make this thing handle better.
- Background
- Just an electrician living out his boy hood dreams. Had a few dsm’s when I was younger. Just trying to do what I wanted to do then, now!