1991 Mitsubishi Galant VR-4 Vehicle Profile & Build Thread

RACER-X's Galant VR-4

Mods-Bolt-on: 99 GSX - Turbo XS Type RFL, HKS Super Drag Exhaust, 3" DP, Intake, Apexi FMIC, A.R.D custom 2.5" uip/lip, HRC Super 20g, ported o2 Eliminator housing and Manifold, Greddy EGT Gauge, Greddy Boost Gauge, HKS TT, HKS 5 EVC, Apexi S-AFC, HRC 625cc, Walbro 255 FP, ACT 2600 w/street disc

Galant VR-4 - MSD wires, NGK Irid. plugs, hack mass. Keydiver stage 3 chip, South Bend Clutch, 2nd gen Mass w/K&N filter, Evo III GT ported exhaust mani, Evo III 3" ported o2 housing, open dump, hacked bcs. and heavly ported 14b.

///93 GSX - 93 GSX ACT heavy duty clutch with 4 pucks unsprung for track use, HKS EVC 6 boost controller, Griffin big core, custom short route piping, 2g Exhaust Manifold, Custom 3" o2 housing w/ext. dump, Custom FP red (not the usual 60 trim comp wheel), 255 walbro pump, RC 780cc inj

Mods-Engine: Non as of yet but Im working on getting new valves, cometic gasket, arp studs/bolts, balance shaft removal kit, fp2 cams, and hks cam gears. Some of listed I have but yet to be installed. Going to do it all at the same time.

///93 - Block bored .020' over, balance shafts removed, JE pistons & Eagle rods, fully ported and polished cyl head, full ferrea valvetrains, FP2 camshafts, ARP head studs, EVO III headgasket, full rotating assembly balanced, HKS cam gear.

Mods-EMS & Logging: ///93 - AEM EMS, AEM Wideband, Auto Meter Boost Gauge, Auto Meter EGT Gauge.

Mods-Drivetrain: ///93 - Stage3 TRE Tranny with welded center diff, ACT Heavy Duty 4 puck unsprung clutch.

Mods-Handling: 99 GSX - Eibach Pro-kit, 18" Konig Conflicts, 18" Axis Speed Six

///93 - GC coilovers w/KYB AGX adj., Rota Slips. 16x8 wrapped in Pilot Sports 225x50x16, 3000GT VR4 rotor and calipers front and rear upgrade.

Parts Wishlist: fp3052, equal length Mani, GM Trans. and all supporting mods for my Galant VR-4