The Top DSM Community on the Web

For 1990-1999 Mitsubishi Eclipse, Eagle Talon, Plymouth Laser, and Galant VR-4 Owners. Log in to remove most ads.

Please Support STM Tuned
Please Support Fuel Injector Clinic

Wiring kiggly mod for auto swap...Manual harness and no TCU

This site may earn a commission from merchant
affiliate links, including eBay, Amazon, and others.

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

DetroitStroker

Proven Member
227
37
Dec 22, 2012
Detroit, Michigan
This is for a 1g using a m/t harness. I have no interest in using a tcu


I have the (10ish wire) main pigtail that is needed for the job. I'm confident I understand the wiring/soldering of the diode aspect however I see there are 2 wires with labels both pertaining to the starter solenoid ("starter solenoid from key"; and "to starter solenoid").

What would be the proper way of hooking up those 2 wires?
 
After looking at my pigtail it is not exactly like that of the kiggly diagram so a little confirmation or help would be great.

On kiggly's harness both of his starter solenoid wires look to be 16ga vs 18ga like the rest of the harness. One black/white stripe and the second black/yellow stripe.
-on my harness the (2) thicker 16ga wires are both black/yellow stripe. Some of kiggly's unused wires were green; of which I have none.


I know there is multiple plugs for the auto trans and this one I have is from a 93.

I still want to confirm the activation wires are: solid yellow, yellow/red stripe, yellow/black stripe, and blue/black stripe for 12v switched power
 

Attachments

  • image.jpg
    image.jpg
    404.5 KB · Views: 170
Support Vendors who Support the DSM Community
Boosted Fabrication ECM Tuning ExtremePSI Fuel Injector Clinic Innovation Products Jacks Transmissions JNZ Tuning Kiggly Racing Morrison Fabrications MyMitsubishiStore.com RixRacing RockAuto RTM Racing STM Tuned

Latest posts

Build Thread Updates

Vendor Updates

Latest Classifieds

Back
Top