rod bearing install

Posted by iluvmy4g63, Jun 20, 2009
Cylinder Head & Short Block - 4G63 cams, valvetrain, pistons, rods, stroker kits, 6-bolt swaps, hybrids, etc. Read this Forum's Strict Guidelines.

  1. iluvmy4g63

    iluvmy4g63 Proven Member

    Joined:
    Apr 7, 2007
    Posts:
    199
    Likes Received:
    1
    baltimore, Maryland
    me and a buddy of mine had a slight disagreement in rod bearing install.
    should the little tabs on the bearings be on the same side of rod or should they be on the oppsite side of the caps?

    or opposite side at an angle? any help or a link would be nice:confused:
    or dont realy matter as long as the snap in to place?
    #1
  2. donniekak

    donniekak DSM Wiseman

    DSM Profiles:
    1
    Joined:
    Mar 23, 2008
    Posts:
    3,180
    Likes Received:
    67
    Surprise, Arizona
    The tabs go into the slots in the rods and rod caps.
    #2
  3. iluvmy4g63

    iluvmy4g63 Proven Member

    Joined:
    Apr 7, 2007
    Posts:
    199
    Likes Received:
    1
    baltimore, Maryland
    sorry. these are a set of eagle rods.. i can't remember if they have them or not
    #3
  4. cheap90gsx

    cheap90gsx Proven Member

    DSM Profiles:
    1
    Joined:
    Mar 15, 2008
    Posts:
    225
    Likes Received:
    0
    puyallup, Washington
    The slots should be there.
    #4
  5. iluvmy4g63

    iluvmy4g63 Proven Member

    Joined:
    Apr 7, 2007
    Posts:
    199
    Likes Received:
    1
    baltimore, Maryland
    resolved. thanks found a pic. of a set thanks for the help for a dumb disagreement..:coy:
    #5

Share This Page