1G 240sx over fenders?

[Dirtrider412]

Have been looking closely at 240sx rear qtr panels and I think they are similar enough to my 1g to maybe buy a set of those rear qtr panel over fender kits I bet with a little trimming I could get them looking good. Anyone have any knowledge of 240s on here?

 

[teamevolution2]

Don't know how this would work. Fuel doors are on opposite sides

 

[Dirtrider412]

I'll figure that out. Probly going to fuel cell soon anyway. I'm just asking about basic body lines I was wondering If anyone has been around both cars to know if the rear is like much more rounded or flatter or anythin..

 

[Dirtrider412]

I'll get it to work I work at a body shop. I'm just wondering how much I'll be cutting off the over fenders to get the edges all down.

 

[Nickolai97]

Please give an update when you do find something! I have been wondering this for a little while now, but I don't want to blow money on some overfenders if they don't even come close to fitting.

 

[Dirtrider412]

Will do I need to contour gauge my qtr and find someone with a 240. I'll spend 250 trying I just got the idea recently

 

[Dirtrider412]

I'm going to rwb my car you guys wait and see

 

[Dirtrider412]

I've already plug welded and smoothed over all the old holes

 

[Nickolai97]

Looks pretty good so far!

 

[Dirtrider412]

Thank you sir. Ya I finally have it close to done. Did work on the engine bay and interior too

 

[Dirtrider412]

You must be logged in to view this image or video.

You must be logged in to view this image or video.

You must be logged in to view this image or video.

You must be logged in to view this image or video.

You must be logged in to view this image or video.

You must be logged in to view this image or video.

You must be logged in to view this image or video.

 

[Dirtrider412]

Update