Im just in the middle of building my head and it was almost impossible to measure my install height. Tried to measure it right without much luck (other brands valve micrometer, using digital calipers multiple differentways), essentially I resorted to all kinds of f***ery in desperation, with not...
Suffered a pretty major valve failure a while ago and I've been trying to sort out the cause for a while now. The head (aside from cams and lifters) was assembled at a machine shop with a full valve job, deck resurface, etc.I'm more curious than anything about the actual valves that were...
I’m looking for a cost effective valve kit package and I found this on eBay… can anyone confit that these will in fact fit a 6 bolt head? The Hyundai part threw me off a bit.
I have some stock parts that I pulled out of my 2g, the valves are well used and missing one exhaust valve due to some damage. The rest are all fine when I pulled from my head, the cams I'm pretty sure are just stock cams if anyone can identify the markings on them further that'd be great.I...
So I ordered new valves, seals and some 268/272 BC cams for my head. My current cam gears have the timing adjusted slightly with the stock cams. I know I need to retune after installing the new cams, but should I leave cams how the currently are or set them back to 0?
So I think to get the experience I am just going to go ahead and rebuild my head myself. I'm not looking to do anything fancy, my car is around 320WHP and I only need to replace my exhaust valves but I figure while it's all out what are other things that should be done.Also if you could...