i think my dad broke the frame its not not moving the correct way. im just trying to get it closed not even functional. does anyone have any ideas on what to do? second pic is showing its too forward to do in the latch.i tried reset and manual switch and nothing has worked to get it into a...
As the title says. What is this? Specifically the black round part just above my thumb. The port on the left side snapped off when removing the hose. This is my first time pulling a motor so I’m learning as I got but I can’t seem to figure out what this part is called as I would need a new one...
I bought a 98 GSX last August that I intend to turn into a track/autox car. I recently put a set of 255/40/17 re71r tires on it with feal 441s on swift springs and took it to it's second autox.Crap for pavement with terrible traction being a sealed lot, I was launching hard (much harder than...
Noticed that the engine I am building has this mount broken off on the bedplate. Of course, I notice this after it is assembled with new parts. Second picture is a bedplate without mount broken off. Am I screwed with this bedplate, or would it be ok to run without that transmission bolt?
Heres some things to take in mind -
1. Fuel pump is good.
2. I have tested 2 ecus (one known to be good).
3. Fuel pump circuit is solid. (I ground pin 8 on the 26 pin connector (fuelpump ground)) and the fuelpump will turn on
4. Turn the key without ground and the fuel pump does not kick...
Alright i need some help with my 1g. car has link v3 and 1260 injectors on e85.
walbro 450 pump
borg warner s366
speed density with an omni 4 bar and gm iat.Had the car running and cruising decent, except for the idle. Tonight i ran into a few big problems.1. I finally figured out the isc...