So I have a 1ga 1.8l without a hood bump, I’m considering a engine swap. I know I would need to change the hood for a 4g63, but what about a 4g61? I know it has a 6mm smaller deck height, would that be enough to keep my hood? Or would I still need a new one?
Hi! I am new to the eclipse platform, and recently purchased my first dsm. Its a 4g37 1g Eclipse 5spd.Upon purchasing this car, I have already had to replace the starter twice, with a new one, in one week, first time due to a fire. Is there any reason my car is having issues with the starters...
Hello,
It is me again now with a functioning 1G 1.8 1990 Eclipse revived after 21 years :DI have noticed something tho.
Whilst I am driving or moving I should say, and if the clutch is pressed in, the rpms do not fall down to the idle 800 but stay at around 1480. Immediately after I stop at...
I'm wondering if there's a difference between each of the balance shaft seals on a 1g 4g37?
I'm shopping for new ones and keep seeing them labeled "right side". But I haven't found any labeled left side... Visually they look the same diameter to me. But they are different colors on my engine...
hey, I could find any info on it anywhere. I was wondering what insurance would look like for a 1.8l 1g for a teen. I know it really depends but I just want to get an ideacouldn't, not could
Hi guys i really need help something had blown my ecm processor (pictures bellow) i need some clues what could it be. Fellow mechanic said that it coul be from bad alternator so i measured it with car started on baterry it had around 14.50 volts when i turned every light on even hazards car had...
It cranked one day, then my battery needed to be replaced so it sat for a week. I put in the new battery, tried to crank it, and got nothing. I thought it was the battery the whole time but I’m suspicious that it’s the starter now. I guess it’s really just a normal starter issue but I wanted to...
ok i have a 1993 4g37 1.8. had to rebuild the head and the machine shop took the dizzy out and now i cant get it to time back right. motor runs! all timing mark are right but the motor is not running right. the lowest i can get the timing down to 5' after and it acts like i doesn't want advance...
I am in the process of replacing 4g37 engine with 4g63 n/t motor. I pulled the engine bay harness from a 92 Talon which was equipped with A/C and cruise control and installed the harness in a '90 laser w/o A/C or cruise. All connectors fit except two 4g63 connectors that have more pins than...
I am taking my 4g37 engine from a 1990 Laser and replacing it with a 4g63 n/t 6-bolt motor from a 1992 Talon. The '90 Laser has no A/C, cruise, etc. The Talon does. I already took both engines out and noticed that some of the connectors dont match up, i.e. the O2 sensor. I figured I might as...
So, I'm going through my 1.8 and doing a balance shaft delete and decided to do 4g63 cam sprocket, since I had one laying around.The problem is that this sprocket is a half tooth off from stock (see attached). I lined up the old sprocket to TDC and slapped on the new one to find it lined up...
This engine has been beat on countless times by me but i have always kept up regular maintenance. but one day driving home from work i was downshifting to slow down and then pop. i turned off power but kept the key in for steering as i approached a green light still rolling about 30mph i turned...