thx man, just quick question the knuckle bushings are all the same size? upper and lower are the same ? the one up is similar in size to the 2 low?please confirm
what is the name of the other ones that will be dying so i can change them ? what needs to be realigned ?i saw 2 old bushings on the rear control arm , can i replace those as well or i have to buy the whole armif you have a kit please direct me i better buy it allalso what...
hello there ,my rear upper knuckle bushings took a crap and now the car is fish tailing and i have an uneven tire wear my tires need a change now because i have been driving it like this since 3 months. i am ordering it now on line because i can not find the bushings nor the knuckle here...
i heard a lot about these plugs BKR6 e-11 and i decided to try them , i did not have a gap tool so i just gaped it down as much as possible i dont know how much but its very tight almost no clearance. installed them and fired it up ,it started normaly , boosted the car up to 16 PSI on the...
did you check for boost leaks to start with ?check also you spark plugs wires and also try to unplug the MASS wires when the car is on and check if the number changes or for different reaction
before you hear our comments , just answer us if the belt is broken or not ? did you open the belt cover to check it first ? if the belt was broken at 80 mph then just follow BogusSVO post and you will not go wrong.
the oil light goes on when the key is on but not engine running , and if i remove this wire that i connect to the oil dummy i will immediately have a BATTERY light on the dash board . so for sure it has something to do with the alternator hence i have the battery light , i can not track it now...
hello there,i think i have different alternator , my car is from Japan and all the wires for the alternator looks differenthave a look please at this pic , the place where i put the circle , this is where i track the wire that i put on the dummy oil light :confused::confused:does...
hi all,i have searched but cant seem to find my problem , yesterday i was on the high way and i saw the battery light on my dash , it kept on going on and off telling me that there is something wrong in charging.i jacked the car and locked under and i found that this wire on the...
Hello there,exact same problem happened to me and it took me few steps to rule out what it was . mine was only a water neck ( it was wraped)do the following :1- double the seal ( rubber) on your radiator cap ( use another seal from another old cap and double it ) make...
thank you brayan for the info and clarification but lets be honest this is an rs eclipse that worth around 2k max so its not really worth it to fix it properly to start with. Once it breaks it goes to scrap yard. Thx again for all the valuable infos on the body work.
you will never accept that you are wrong i guess its human natureanyway just a fact this rust can be properly fixed with maximum of 400 usd, which is the price of a new shell that you want him to buy :)stop explaining and explaining please because its going nowhere. 400$ it is...
if its only engine and tranny its easy , its a lot of work my friend :) seats , dash board , connections , wiring, ECU , fuel lines , paint and the list goes on and onthe price of new fluids alone will cost him more than fixing this cancer rust :) :thumb:
you are 100% right but moving the drivetrain in a new shell will cost hell a lot more than just fixing that cancer rust. so he is better of just fixing it. IMHO
you asked for EYECANDY :)IMHO many DSMs will not stand out with white color , very rare white dsms are an eye candy its not impossible but its harder than RED or black for sure. i saw only few white eye catching dsms,i am talking about 2g here.candy red is going to be more...
buy from ebay there is a short ram with filter and adapter and all for around 35 USD on ebay , bought it before and tried it, its ok and makes your BOV way louder :) thats the only benefit i guess other than it looks nice in the engine bay also. maybe the spool time is slighlty very...
Thanks for all the infowe have around 30 cars all from Japan here in UAE, around 20 Autos and 10 manual and i owned 3 of them and sold them off and now i bought one manual back again.parts are pain here almost impossible to find parts , i am in need of head lights and cant find...
just my first post up here with the picture of the fuse boxthe last relay on the right ( lo ac fan) with relay number 4 which is ( rad fan lo) that is under the (tail lamp) i connected them with one wire only.
thank you very much , just one simple quesiton now , shall i just go back to my previous conneciton wiring as per my first post ? becasue with this mod i can see maximum 95 degrees on my after market temp gauge wired from the upper radiator and today when i did the Vfaq way i can see its 98...
thank you again what i want is to run both fans on HIGH when the ac is on and also when the tempreture gets to target when the ac is off for examplewhat can i do to make both fans on high when the ac is on and also when the tempreture reaches the limits when the ac is off.can you...
yes thats the way but without the switch to keep them on all the time and control them, i just connected relay 5 and 2 together with one wire as per diagram so they can be on together and off together only.
thanks for the nice reply, its manual.Ok now the way i have it is as follows. ac on , both fans on but the ac fan is on low and rad fan is on high, the problem here is when i reach 210 degrees the ac fan never on high. It will just stay the same. Now i changed to the vfaq way and when the...
can you please share some information about the AC fan speeds? how does it speed up and when? my ac is always on but i never seen the fan on high speed. when it should be on high ?also one more question , i have connected the two fans ( ac and radiator) so they can kick together and off...
start with the basics and do some reading there are a lot of info on MBC and the boost gauge , you dont increase boost just like that , boost gauge is a must and also i hope you hooked up that MBC correctly.
take out the Biss with double tape , put the double tape on the screw driver and stick it out . done it so many times.1- check your gap again and check the wires
2- make sure all the boost leaks are fixed
3- check your injectors ( pull the connectors one by one and check for...
open the cover and check the timing belt , check if all is alligned , if yes move forward to boost leaks, ignition and other stuff. if the belt is not alligned DONT drive the car.
Does it get better or worse when you push the clutch in ? They will go a long time but get progressively worse until they sieze up and ruin the pressure plate. If its not a loud squeal I wouldnt worry about it for now.
it happened to me before it end up to be the water neck itself where you seal the cap , it was wrapped and it was allowing collant through and not to be pressured correctly because it did not seal well with the cap. after i changed this neck its perfect . no boiling no pushing coolant...
white smoke is water / coolant and not OILdo a leakdown test and check if you have a blown head gasket ( hope not), can you tell us more about the car condition , what else is happening other than smoke? do you still have power?
hi all just wondering whats your normal operating tempreture on stock gst? I mean stock t25 with heatshield on and stock cooling system? i installed a water temp gauge reading from the upper radiator hose and i have both fan on when ac is on and the max temp i can see is 80 to 85 degrees and...
MAN you have done a fantastic JOB with these sequential tail lights , hours and hours of hard work for sure , this is NOT RICE at all , its actually Amazing and specially how you open the HAtch. :thumb::thumb::thumb::thumb::thumb: