Im running v3 speed density i have 880cc injectors and a h1e turbo in a bolt on 55a/r housing what should i fix in my tune

Drive train: Supra r158 Trans r158 to 4g63 adapter bell housing Custom Drive shaft aluminum flywheel act 2600 PPEngine: 2.0l 4g63 Ross 8.3 pistons eagle 6 bolt rods balance shaft delete ARP head bolts ARP Main Bolts Stage 4 ported head SP Guides SP dual valve springs and...

Well i decided to change my check somethings under the car today and i found something weird with the fuel setup the car has, when i bought the car i was told that it had a inline bosch fuel pump but when i look at it today it did not look like a bosch 044, i decided to pull it off and look at...

Hey does any one no were to get the pintle caps that come on the pte injectors?

I was hoping some one would share some info to a beginner on getting started with trying to tune with a e-prom burner. I am very new at it but i hear that it is not that hard to learn. I have a key driver chip in the car right now but im getting some new things done to the car and i will need to...

Well I jus wanted to post my parts list and show some pics of what i have so far.Well here is a list of everythingHX35 Turbo Custom Turbo manifold 46mm external wastegate 3” Down Pipe 3” exhaust Honda Civic aluminum Radiator FMIC 2.5” Ebay Core 2” hot I/C Pipes 2.5” Cold I/C...

Well I have decided that it is time to raise the power on my GVR4 setup. I’m Going to be upgrading from the stock turbo to a holset hx35. I will be using the original holset housing and having a custom turbo manifold made to make sure it fits my engine bay correctly. Some other things i will...

I Was Wondering if any one could share some good info on which head i should go with for my build. I am planing to do some porting on it, i will also be upgrading the valve train up with some 280 hks cams and brain crower springs and retainers. I will be revving up to 7.5 to 8,000 rpm most...

Has Any One Tried Running this Turbo Before, Is there any turbine housings that can bolt up to it or will it need a custom one.

I am looking for any information on any projects done that have put a manual fwd 4G63 in the rear of any vehicle... I have seen pics of a fiero and some duel engine talons but no detail info about them. Some of my questions are, what needs to be done to mount the shifter assembly in a way that...

I am confused on what firing order is used when you do a 2g block with a 1g head into a 95. I am using the 1G crank angle sensor. how do i set up the spark plug wire's.

I want to build a 2g 7 bolt block into a 2.3L stroker. I no i need the 4g64 crank and the stroker pistons in the 4g63 block. But when i was reading up on this there was a little confusion on what rods to use and some clearance problems on the crank side.Well basically these are my questions/...

Hey every one, I was looking at the MS setups and i am very interested in running it in my Galant VR4. I Read that the msII has some features that i would benefit most from. The larger tuning maps, the Knock control, Launch Control features are things i would like to have in my MS build the only...

I own a 91 Galant VR4. I began modding it i started with a MAF-T, Then with a E-PRom Chip Stage 3. After The Stage 3 chip i installed a S-AFC witch was improperly installed and i belive led to the ecu being burnt. After This Purchest a AFC NEO wich i installed but the Car still did not start...