I like what you have created. I’m in line for ordering one! That shipping cost to the USA though
In the end it’ll be worth every penny. Awesome design!!!
It could also be the balance shaft bearings gone bad. That knocking sound will travel through the engine and sound like it is coming from different places. Like 97gst1126 said check the oil for the shavings and the oil filter.
You might want to reconsider where your getting these engines from. I know if you keep going this route your bound to get one that is working right. The question is will it last after the warranty has expired? Then your back at square one again. I don't know your financial situation but if I...
Check to make sure all the heat sheilds are tight and not vibrating anywhere. They come loose some times. Just a thought. But really sounds like the TOB to me from what you describe.
You should look into the ID2000 injectors. They are the perfect injectors for a methonal set up. These injectors flow a huge amount of fuel and you will more than likely only need 4 of them. Check them out if you have not already. :thumb:
Injector Dynamics
I had the same thing happen with my turbo and it had a lot of oil left inside of the exhaust. All you can do is drive it for a long distance to burn off the oil or replace the exhaust system. I cleaned my cat back out with brake cleaner and removed the cat completely. If you still have the cat...
My experiences with crankwalk have been do to high pressure clutch pressure plates. They put an excessive load on the crankshaft. Then before the clutch was change I had the engine rebuilt. The machine shop did something wrong and the engine walked on first start up. It could have been something...
I had John Shepherd modify a AWD tranny to FWD for me a while back. It works great. I also had a KAZZ lsd installed and the traction is awesome. With slicks the car pulls 1.7's and sometimes 1.6 60' times. I like the AWD gearing better than the FWD's.
I had a problem like that before and later found out that the ignition switch was bad. Replaced it and it worked perfect. Check for power at the switch.
When they decided to make the VR4 convertible they had them modified threw a company in California that can turn any car into convertible. I had one roll into the dealership I worked at to have the top repaired and found out that no parts were available through the dealership. This is why they...
My 95 GST ran awesome with 26" slicks set at 9psi. It would pull 1.7 and a couple of 1.6 60' times most every time I launched the car. I would not use launch control. I like to rev launch in the range of 4500 and 5500 while slipping the clutch a little. I broke less axles this way. I could never...
You should go ahead and just put a 6 bolt block in while it is apart. Keep away from those heavy duty pressure plates. I had the same problem just after a rebuild in my 95. Then I went and bought an EVO3 engine and at 400hp and 4 years later I did not have 1 problem with the thrust bearing.
Vibrant sales a universal muffler that is all black. Looks as factory as you can get. I put one on my GST after cutting the Tanabae muffler off and role past the cops hitting louder then normal exhaust notes and all they do is look. I have not been pulled over since the change.
Ron Shearer just made this manifold for my 2g project. It's placed to sit right at the edge of the front bumper. No intercooler will be used as I am running methanol. Note that there is still room for a half core radiator. This is one sick manifold and Ron has out done himself on this one...
yeah but how much power and torque are you putting to the wheels. roasting tires wont hurt a clutch. if your at the track and you hook up really well that is when the clutch is most likely to either grab or start slipping. so make your choice's wisely.
you should be ok but you should still call john shepherd and ask him some questions just to be sure. it should be right if its from the same year but mitsubishi does a lot of mid year changes and their is no real way to tell if that was one of them. later.
you are probably better off buying a BBK throttlebody. there's is a 63mm i believe. wont hurt to check them out. i have one on my car and works great. no probs.
hey i called the dealer and they show that your tranny code is correct but... the gear ratios may the off because it has the last 4 letters as being different. if you do use that tranny make sure you also have the right transfer case. those gear ratios also have to match or the transmission will...
naw dont get it. looks like a comp clutch kit. i suggest www.speclutches.com and go with the stage 3 plus. all of my customers use them and have had great success with them.
yes its the lifters. what happens is that the lifters go bad and trap air inside them and collapse. no oil can cycle threw then no more causing the ticking noise. the revised lifters for your car are from a 2000 and up galant 2.4 liter i think. do some more reseach on revised lifters. that...
hey does it make the noise when the car just sits at idle? if it dose then press the clutch in and see if it goes away. if not something inside the tranny is broken.
check the TPS sensor. make sure it is adjusted to within spec. and make sure the idle air speed screw is correct as well. turn it in all the way and then turn it back out 1 complete turn. if that dosent do it then check the base ignition timing with a timing light.
do a compression test on each cylinder with the throttle held wide open during cranking and the injector resistor pack unplugged. doing this will give you the most accurate readings. all cylinders should be within 10% of each other and at least 150 psi. if that all checks out to be good then...
I have 2 AEM's for sale at 1,450.00 each. At this price they wont last long. Let me know if your up for getting one. They are for 95-99 Eclipse turbo. :dsm: Great deal dont pass it up. PM me if you want one :thumb:p.s. no they are not stolen. One is out of my car and the other is out of my...
hey maglin, i would love to see you accomplish your goal. never herd anybody sticking with stock ecu with that much power. if you do more power to ya. its probably going to be kind of hard but if it were not it wouldnt be any fun nore worth doing. keep me posted. :thumb: :dsm: