Hi, so my 1G 6 bolt 4g63 block is getting built. The machine shop had to take 0.010" off the block deck, it wasn't in the greatest condition obviously. I have a rebuilt 2G head with SS stock sized valves to go with it, it has had a minimal amount of material removed from its deck, a few thou...
I have a 1GB TSI AWD, manual transmission. I have been searching for the fender splash shield that goes directly behind the side-mount intercooler. Mitsubishi only sold this splash shield as part of a kit, mb861272. Finding this kit new is damn near impossible best I can tell, and buying used...
I'm having a hell of a time finding CV boots for the rear outer joints for a 1G AWD, 4 bolt axles. Can anyone help me with a part number and where I can order from? RTM doesn't have anything listed for rear outers, same with JNZ. Rockauto, autozone, advanced, they all come up with nothing. I...
Anyone ever try using an AOS (air oil separator) on a DSM? They are pretty common to the Subaru community. I am pretty surprised most just go with a catch can that vent with a small filter on a DSM. I always thought the vacuum was useful in helping to seal the bottom end. Any thoughts?
Anyone with a dual pump install, I have the full blown setup. -8 feed, -6 return. I am a little concerned because the return line returns at the top of the tank. There is no line inside returning the fuel to under the fuel surface. Primarily I am worried about aeration. I was thinking of...
Was installing a dual intank full blown setup today on my 1g awd. No install instructions or anything with it, and i can't find any pics of a 1g install. The only way I could see to be able to fit the level sender and both pumps in was to locate the level sender and pump inlet filters on the...
Silly question of the day, when I received rear braided brake lines for my 1GB AWD, 2 were short and 2 were long. Do the longs ones attach to the caliper and the short ones to the hard line, or visa versa? My car has been torn apart for a long time, putting it back together with some custom...
Just installed new rear wheel bearings in a AWD 1GB . The install went great, torqued the spindle/hub nut to 140 ft-lb's. The drivers side rear wheel rotates great but has a slight, very little, play in all directions (like if I were checking for a bad tie rod up front with car jacked up pulling...
Just curious, so I have ASA installed on my PC for finding OEM part numbers for my 1G DSM, but more than half the time the parts are no longer available from Mitsubishi. Every time I have to call my local Mitsubishi dealer and have them look it up. Anyone know of an online resource to check...
Kind of surprised search history didn't come up with something on this. I dropped the gas tank out of my 1g AWD yesterday. Has anyone tried separating the gas tank halves to be able to better clean it out and possibly restore in the inside? I'd like to wire wheel the outside a bit and...
Anyone know a part number of a plug to fill this hole? It is the hole where the harness for the AC comes through by the front drivers fender to the AC fuses and relays? I assume cars without AC didn't have the same harness, and had come sort of filler, but I can't find a part number anywhere...
So I've been searching for manual racks lately for a build I'm doing, and stumbled upon the infamous unicorn rack at carsteering.com, anyone ever heard of this place before?It almost sounds to good to be true, 1994#Mitsubishi#Eclipse#Manual Steering Rack from Car Steering Wholesale400 bucks...