Put some time on it
I reinstalled shafts , and conected wiring , hoses etc
Im doing some stuff only at saturdays after closing my shop
Some of the big changes are on turbo setup im back to the 67mm hx40 and upgrading to methanol friendly injectors and a mech fuel pump system.
Gonna try 100mph...
Im working trying to quit a clog coolant lines on block of ecoboost 3.5 turbo , customer mixed 2 kinds of coolant and they gelated so is overheating for lack of coolant flow
Im Doing a front end for my 80 luv v8 swaped.
I did from scratch since i didnt have the funds for the feather carbon front end
At the end i like it to.much , i think i gonna spray color today
Well, I had car working on a little hot temps than I like, so this time I did some general maintenance I decided to improve a little coolant system.I know its been discussed yet, but I will leave my personal experience on my 2g DSM.Causes of bad cooling:1. Lack of airflow, after you put...
No oil filter inline on mine
Tune is in spot some tweaks to get wbfactor less% but is almost done there , even you can live with , some more rpms and it should move more air, seems like youre on ethanol
Gt2560 said no more (my mistake)
So grabbed a gt2871 to step up a little without changing a lot of stuff
Gt25 was 45-46mm comp inducer
Gt28 now is 49mm inducer and exd 71mm
Might it should be worthy for a cople more lbs min or so.
So need to do some pulls to log new air flow
Comp maps...
I used on my own carsCometic mls .... worst gasket i had (surfaces were on 20raFelpro 9627 ..... good choice and great if you put a set of arps too , it holds 40 45 psi even some shot of n2o without problemAjusa... 40 -45 psi without problems with arp l19 on headAlso used some called...
Spend more time making this fender exit , its almost ready to weld complete , just some tweaks here and there and i need incorporate wg dump to it and is ready
Also purchased a flux core machine to start building my own stuff , i started one fender exit exhaust on a friends car , pipes are just pointed to make the form then will weld all together , im not a welder so is not impressive but im learning and think is a good starting point.
Just match trims with dead time and use sd adjust option and it should line.
Closed loop always will target 14.7 redardless what open loop maps are , and at ecmlink isnt an option to change that