Thanks for the reply, at this point im mainly wondering if you think it could just be improperly adjusted or is it just not a big enough clutch?

Well, just got done doing a trans swap ( auto to manual) Supposedly the manual is a shep stage 3 with short shifter ( no way knowing unless i take it apart) and act 2600 cltuch.. Anyway, just got it running better so i went and drove it for the first time. romped on it a couple times... then i...

I am going to first block the not needed holes in the fiav since i knoe this is not done.. wether iy gixes it or not it should be done.. ill test it out tomorrow and let you all know. 1 step at a time. ThanksPLugging the 2 holes on the fiav fixed it! Thanks for the links and everyone that...

Alright i just went out and started the car, i once again spray EVERYTHING that i could think of that would have air flowing through it with carb cleaner and NO Changes what so ever. After i let the car war, up it DID lower to 1500-2000 but still surged badly. just lowered down. I see in this...

Hey, I have a 1991 Talon ( 1992 engine ). We just swapped the car from auto to manual, and while doing so we took off all the intercooler piping to get easier access. ( my throttle body had a fiav block off plate or what ever that is where the ISC goes) So while we had the IC piping off i...

When i get everything istalled and fired for the first time i will get a reading and ill get back to you! Thanks :)

I am in the proccess of putting an hy35 on my 1g talon. I have the -4an Feed line (off the Oil Fitler Housing) , and -10an return line, both from Extremepsi.com. Will i have any problems with this setup? And Should i run a restrictor? If so what restrictor should i run? ( links would be great )...

Hey, i got most of the stuff ordered to finish swapping the turbo in.-10 an return line kit- EXTREME PSI : Your #1 Source for In Stock Performance Parts-4 an Feed line fitting- EXTREME PSI : Your #1 Source for In Stock Performance PartsAlready have a -4 an feed line running...

Thanks for the reply. I understand exactly what your saying. With that being said im going to throw it on anyway and worste case sinario i will take it back off and rebuild it, or just buy a new one if it is shot as i can not rebuild it myself and i could just buy a good one for cheaper then the...

Hey guys, i went to the local diesel shop in town and brought my turbo in and was going to see if i could get a rebuild kit for it and they said that the amount of shaft play (minumim side to side) was acceptable and said it didnt need a rebuild. So with that being said, i plan on putting in on...

Anyone else? Hows that log look? Would still like to get it figured out

thanks for the comments... i did plenty of searching when i had the time. And 90%i of the stuff thay came up was hx35 and nothin really what i wanted. But.now that i dont have to worry about it fitting.... the turbo has little up and down play... but.no.in and out... should i still rebuild it...

Thanks for the comments... and you say it wont fit? The kid that originally had the car said he.had an hy35 on it...i think he said he had to grind a little bit of the hotside of the turbo to get it fit. Is there any other way i could get it to fit? Thanks jordan

How about just the rebuild kit itself so i could rebuild it myself? Any recommendations?

I just bought an HY35 turbo for my 1991 talon. Its set up to fit on my turbonetics t3 manifold with an external wastegate. Anyway, The turbo does have some shaft play, up and down, no in and out. Just wondering where you guys would recommend buying a rebuild kit from, and what i should all...

here is the log you asked for. let the car warm up for 5-10 min, so its not at operating temperature but its definatly not cold... i let it idle, did a quick throttle, idle quick throttle, idle slow throttle let it idle, was idling high, then it actually idled back to 1000 after a little bit.

Ok well Im going to kind of restart this question and maybe ask it in a little different way.. Like said above the car is fully built. ( if you need to know whats "Built" about it please ask)Car runs on e85So the car Starts fine runs ok at idle. Drives down the road great ( only driven...

Thanks for all the replies and suggestions, gonna be out back working on the car today anyway so ill try and look for a vacuum leak and ignition timing if i can figure that out haha. And kruger, you mean like a data logger? Yes, i have DSMLINK 2.5. Thanks

Thanks, ill get to it! Is there some sort of vacuum hose diagram or something that would help?

I got a 1991 Eagle talon turbo, fully built. Just got the car and i just had a guy send me a tune for it (e85). The tune is set up to run at 1000 rpm. But sometimes it will run at 1500 and stay there. And i got it up to operating temperature and it threw it in park and almost sounds like it had...

Nocardick: thanks for the respoce. The car still runs like crap (doesnt feel like im getting enough fuel, and idles arould 500 rpm and dies. I think today im going to drain all the fuel out and start fresh. see if that changes anything, already put new plugs in. Would it help if i posted a log...

Thanks! Im just hopin he didnt do to much damage! :/ really hopin to get that tune sometime soon so i can do a good compression test and start working on it!

Thanks for the replies. Wes_393: At a cold start up and idle the a/f was at 20! Warmed up at idle it was still at 14.8! Im scared to run it lol. Only one spark plug was melted ( i know still not good!) so im hoping i can get this base tune to i can atleast run it without damaging it to get it...

Thanks for the reply. a guy is nice enought to help me get a tune that i can atleast drive on for right now til i make sure nothing is wrong with it, that way i can get it up to operating temp saftly and do another compression test with a new ignition so it constantly is turning over lol. Hoping...

Hello everyone, my names jordan and i have been lookin on this site for quite some time while i have been looking for a 1g talon. I was looking for a stock one that i could build myself, but with no luck i came across one that has been completly built for a price i could absolutly not refuse...

I appreciate all your posts! But, with lack of finding a nice shape talon close to stock. I found one that has already been built... for cheaper then i could have bought a stock car! Ill post a new thread, check it out if youd like! Thanks again for the help Jordan

Hello everyone! I am new to dsm's/turbo vehicles, and sort of new to the site ( been researching everything for some time now here). First things first, my names jordan. And i do not YET have a dsm( trying to find the one). Before i buy any kind of vehicle i have to do my research so thats what...

Thabka for the replies guys.ill go do a little more research kn the stuff you have listed and add iy to my list! Britdog: what size injectors woild yoi recommend? How uch boost could i run on that 16grim witg the 650ccone inectors? (Somewhay safly) and also what brand exhaust/downpipe do.you...

Awesome thanks. Ill add that to my list. Thanks jordan

Sounds like a good investment...does it have.launch control and stuff like that? And how hard is it to tune yourself? Never tuned anything before) ot should i let someone else do it? Thanks jordan

Thanks for the response, How much is an ecmlink and how hard is it to hook up? thanks Jordan

Wide band has been listed thanks!

Hello everyone! I am new to dsm's/turbo vehicles, and sort of new to the site ( been researching everything for some time now here). First things first, my names jordan. And i do not YET have a dsm( trying to find the one). Before i buy any kind of vehicle i have to do my research so thats what...

Thanks for the comments, so you guys think it would be worth trading a raptor 660 for it?

Hey guys. New to the forum and the DSM's. Been looking for a 1g talon/eclipse but i have not had too much luck in my area, i came across a 2g, 1997 Eclipse, fwd, 420 a turboed. I have been doing alot of research on the 4g63's but havent really even thought about a 420 a. I was wondering if you...

Hello everyone, im new to the site, and dsm's. I Have been thinkin about buying a Turbo Eagle Talon... but before i do, i have several question i would like to know, so i know what to look for... and some questions, just so i know. I tried using the search, but my computer is super slow at the...