1991 Talon AWD
Has be on non-operational registration for a number of years.
Just acquired the car and I'm selling it as is. Starts and drives.
Ive noticed some vacuum leaks and I had to rewire the injector resistor pack since the rats chewed through the harness. Not sure where else they couldve...
Hello, I have an ACT 2600 pressure plate with a 6 puck sprung disc. Also have a Xact Streetlite Flywheel. These are all for an AWD Six bolt.
Ran for 2,000 miles, two track days. Replacing because I
wanted to try out a new setup that didn't give me a body builders left leg.
Pressure plate and...
I have been running a thermal for about 7 years, sounded amazing for 4 years, and it still sounds great, but I feel it has lost some of its throatyness? The muffler is rattling about six months ago, perhaps I've been playing with the antilag too much. Anyway, I pulled it off and tried to shake...
When you put yours in, did you just get the other wiring tucked somewhere.
I'm sorry, just trying to prepare everything I might need.
Did you run your own cable, or did you use the stock alternator?
Did you go straight to battery with an inline fuse? or did you go to fuse block and used the...
I've searched for this, but haven't had any luck finding it.
Anyone who has done a relocation for their alternator, is one of these one wire alternators ok? Someone else had recommended it, they said it all worked fine, but all the post I see on tuners use the stock pigtails, or somehow re-wire...
I agree, I would definitely recommend looking into the holset side of things, if you wanna keep your stock manifold you can just run a compatible housing, but I would recommend an HX35 with a t3 twinscroll housing.
The proper holset will spool similar to a 16g and make as much power as a 20g.
Do you know how to inspect a clutch? If you could get your hands on some pictures it would be great, I mean he is your friend and I'm sure he's not trying to shaft you, so if its a 2600 and less than 500 miles, and its in great condition get it, even if its a 2100 it doesnt matter, since youre...
New or used? How does he drive the car? If used, how many miles? How much power was getting put through it?
Post some pics. If its in great condition 1000 miles, I would say yes.But then again, is your car built?
It wouldn't hurt, well except for the sweet left thigh and calf you'll have.
If...
So you can actually take the bracket which holds all the solenoids, unbolt it, remove all the solenoids except the fuel pressure regulator one, unless you have an afpr, you can run without a solenoid(don't quote me on this, or the color of the line, but i do believe its the one with the light...
Seems daunting at first, but the only thing that can be done is to pull out the wiring diagram and start checking for voltage.
Re-check your fuses, especially the 80 amp alternator one.
Check to see if youre getting power to the ignition switch, would probably the first step.
If you're doing away with the egr and charcoal canister, just unplug your emission solenoids from the wiring harness, and get rid of all that extra "vacuum leak potential"
The solenoids are the ones on the firewall, drivers side. Then you can remove all the hoses going to them.
One of the...
http://www.dsmtuners.com/forums/newbie-forum/372386-alternative-fuel-e85-e-85-ethanol-corn-gas-e70-advanced-merged.htmlI've been using this site for 8 years or so, but only registered for 2 years, if even that.
Point Im trying to make is that everything and anything I ever needed to ask for...
Although debatable, especially since our cars have water cooled turbos, turbo timing your car is never bad, but people say that its not necessary.
Now do you have to go out and buy a turbo timer? Not really, I usually sit in my car reviewing my logs after driving anyways so that's enough time...
Yes, that's the vss. Take it out and see if the actual spinning part, its flat on one side "keyed", so it rotates with its female counter part didn't break off inside and its not actually transferring movement to the speedo in the back of the gauge cluster. If its not broken, then go and check...
It is for emissions alone, will not help fuel economy, but will also not hurt it. You wont pass smog, and you will throw a code, then again I dont know what emission law's are like in New York.
I got one of the last short shifters from jnz from their last batch, I have a Symborski kit, and all the bushings are solid. There is still some play, but this is due to the fact that we have cables I believe, but it did alleviate some of the play that I used to have when it was stock.
I chose...
lol he knows what he means by get a 255, and an afpr,which is actually adjustable fuel pressure regulator, but I digress, he is saying what to the fact that you will not feel any difference whatsoever; being that you're not letting anymore air in, your computer maps haven't changed, so there is...
To continue off topic, sorry, from what I understand; wouldn't the smaller turbo need a bigger intercooler in the attempt of maximizing turbo output? Which would cause small turbo to be in very inefficient zones of its compressor map, thus creating more heat than a larger turbo would since its...
Terry's Talon Troubleshooting Tips #3 - Fast Idle (aka. Idle Surge)
Idk if you have tried that out, or if that's even your problem at all, but it just doesn't make any sense for the BOV to be going berserk when you're not snapping the throttle at least, I don't believe the ISC can move that...
I bought a 90 Talon recently; it had all the vacuum hoses disconnected, and it would idle surge, so I finally installed all of them just so I could start diagnosing the problem correctly, found out that there was no continuity in the ISC, so i got another one, which also only had continuity...