I'm looking for a replacement hard upper intercooler pipe for my spyder. I found one flanged for my bov but it's for a 1g and wanted to know the difference between the two. I know the intercoolers are different but wasn't sure about the actual upper intercooler pipe.Thanks,
I blew a intercooler coupler on my way home last night. I couldn't get it to crank back up it would just turn over. I replaced the coupler this morning and was able to get it to crank it idled fine for a few seconds then died. I thought maybe it was fuel related because I couldn't hear my...
I'm about to change the timing belt on my 2g talon. I pulled the cover off and there is significant wear on the timing belt side closest to the engine. I haven't fully disassembled everything else yet but kinda wanted to know if anyone has ran into a similar problem before.
Long story short my engine mount broke loose from the block. I had to remove the mounting bracket attacked to the block to drill and tap out the holes. My problem is I had to pull the bottom portion of the timing belt off to remove the bracket but I didn't rotate the crank to top dead center...
I recently installed a translab shift kit every since the install I don't have overdrive/4th. I thought it might be the end clutches so I replaced them with a set from ipt. Then I got a 1750 cel and limp mode so I swapped out the shift solenoids. All this and I still don't have 4th. I have...
I just put a translab stl-175-hp shift kit in my dsm. After I got everything put back together I took it for a drive everything was fine until it went to shift into 4th it engaged for a moment and then kicked back down into 3rd. Now it won't engage 4th at all and if I drive it for an extended...
I was in the middle of changing my shocks when I noticed the cv boot was torn on the drivers side axle. I went to go change it and noticed I couldn't get the half shaft out of the transmission. I used a tire iron and bent it when I pushed with both legs trying to pry it out. I then went and...
I was driving home from work the other day I stopped at a traffic light about 1/2 mile from my house. I turned right when I shift from 1st to 2nd there is a loud thump from the rear end then a constant popping/clicking noise. I limped it home with the popping/clicking continuing at anything...
I having issues getting a firm feel from my brake pedal. I've bled the system multiple times and the pedal is still spongy. If I bleed the system with the car off the pedal is firm but as soon as I start the car the pedal goes soft again. I bled them in the following order RR, LF, RL, RF...
I recently picked up a 2g awd for a good price but have been having problems getting it running 100%. The car will idle fine but when you try and drive it as soon as you hit boost it bogs horribly and sometimes backfires. So far I have replaced the spark plugs (gapped at .30), changed the plug...
I picked up a 2g recently but it has a few problems. Recently I've noticed that if you pump the brakes while the car is idling the rpms will drop and the car will shut off. Any idea of what my problem could be?
I'm in the middle of installing new bushing in the rear of the gsx. But for the life of me I cannot get the rear knuckle removed from the car. I've basically removed the bulk of the suspension and this thing isn't budging any advice?
I just picked up a 95 gsx but the rear suspension is shot. Both shocks and wheel bearings need replaced. I also have a 95 rs that was totaled in a front end collision. My question is can I use any of the suspension parts from the rs on the gsx?Thanks,
I'm having a problem with my a/c this year. It was working great last year but now it will only blow hot air. The belt is fine, the pulley on the compressor spins, checked the fuses, swapped relays, both radiator fans work, but when I hooked an a/c recharge gauge up the reading were in the...
I was driving today and noticed that sometimes while driving the car feels like it hits a brick wall and the shifter shakes violently while in gear. I can let off downshift and everything is fine. The car has been sitting for about 5 months but the clutch, flywheel, and pressure plate were...
My gf's ac belt broke and I'm in the middle of replacing it but I'm having an issue. I'm only seeing two pulley's and the new belt I bought is too big for those two pulley's. It looks like there should be a third pulley somewhere but I'm just not seeing it. Can someone give me a diagram or tell...
I was driving to work on the interstate the other day and my rpms just dropped to 0 but the engine was still running the car wouldn't accelerate though I downshifted to 4th and the engine revved up but the rpms stayed at 0 and the car still didn't accelerate I just coasted onto the shoulder...
I was in the middle of installing a pair of Goodridge SS brake lines on my Talon. I accidently over tightened the fitting and it ended up splitting right down the middle. Do I have any options or am I stuck buying a pair of new brake lines? Here is a picture of the damage:
I wasn't sure what section to post this but I'm in the middle of doing a goodridge ss brake upgrade. I got the kit used but am missing 2 fittings to complete it. The fittings that I already have appear to be "AN" fittings and threaded 1/8th of an inch (I could be wrong about that). I searched...
Today I was driving and when I came to a stop I could hear a slight scrubbing/grinding. It sounded like it was coming from the passenger side rear of the car. I've replaced the front pads recently but never the rear since I've owned the car. I always assumed that the rear brakes were just for...
I've searched but couldn't find what I was looking for. I'm in need of a new oil pressure sender so for all the people that are running any of the faze line of gauges where do u get new electronic senders for the gauges? Can I use any other brand of gauge senders for the faze gauges?
I've been having problems with my eclipse starting since about a month ago. It started when I was in the hospital. I had my gf try to crank it to keep the battery charged but she told me it would just turn over. When I got home I went out and it cranked right up so I was like ok...but I let...
I have to have emissions done before the end of this month. All of my monitors are completed except the catylist monitor. So far I haven't been able to get the catylist monitor to reset. I have a test pipe could that be what is stopping that monitor from completing? Will I pass the actual...
I have a 95 eclipse 420a non turbo. Every since I've bought the car the speedometer has never worked and the odometer only moves 1/10 of a mile for about every 20 miles that u drive. I thought it was just the speed sensor. I ended up replacing the whole tranny due to bad syncros. The...
I have a 97 eagle talon and have to have emissions done to it by the end of this month. Last year I couldn't get it to pass because my stock ecu had the fault where it wouldn't allow the monitors to reset. I was able to get a friends shop to write me some fake receipts so that I could get a...
Like the title states I just finished a flywheel and clutch install. My problem is when I try to turn it over it seems like the flywheel loosened and its making it wobble and hit the bellhousing but I'm not sure. I took the flywheel inspection cover off and the flywheel doesn't feel loose. I...
I recently bought a used ACT clutch kit from someone local. The problem is he pulled it out of a wrecked car and doesn't know which ACT clutch kit it is. It appears to be just a standard street disk. The pressure plate is yellow and clearly has ACT on it. Below the ACT lettering is the...
I am having problems with my car starting so I decided to replace the ignition switch. I took the old one out and decided to take the snap ring off and take it apart. I put it back together and put it back in the car to see if it helped. I must not have done something right whenever I put it...
I can't figure out why my car won't turn over. Whenever I put the key in the ignition all the electronics work but when I try to crank the car nothing happens and everything was fine yesterday. I replaced the battery and battery terminals but still nothing. I also checked all the fuses. Is...
Earlier today I was on my into town and I go to shift gears and the pedal went straight to the floor and stayed there so I coasted into a gas station. I checked the fluid reservoir and it was bone dry so I bought some brake fluid and filled it up. Then I tried pumping the clutch to build...
As the title states I just got a XD-16 gauge for my LM-1 wideband. I already have the LM-1 controller hooked up and wired so it can be logged with dsmlink. I want to install the XD-16 gauge so that I can monitor my air/fuel ratio without having to look behind my seat to see the reading on the...
I recently tinted my tails on my talon with vht niteshades but I think I may have applied too many coats. I was heading home the other night and passed a a couple of cops sitting in a parking lot talking about a mile ahead they come flying up on me and immediately pull me over and harass and...
I just got a set of used halos from another member. They came off his 95 gsx and he is doing the 2gb conversion so he sold me his old ones. I was putting them on my 97 tsi but as I was putting the bumper back on I noticed a gap in the corners of both headlights. I was under the impression...
I just bought an Innovate LM-1 wideband and have a few questions about the install. I already have it installed in place of the factory 2nd rear o2 sensor. What I did was just cut the factory sensor off and left the harness. My plan is to wire the analog output of the wideband into the...
I will start by saying I did search but couldn't find the exact answers I'm looking for. I just got a aftermarket electric oil pressure and water temperature gauge and got a couple of questions. I will start with the oil pressure sensor. I plan on mounting it to the oil filter housing and...