my car overheats when i drive it on the highway 80 mph
drivers side fan doesn't kick in but the other one does. needle stays at 3/4 of the way thru the whole trip (60 miles) but when i was getting home the needle when all the way up then i slowed down and it when down to 3/4 quickly then up...
car wont go pass 4000 rpm when moving and at idle.i just installed the greddy ic pipes and greddy type s blow off valve before this happend.also when it reaches 4000 rpm the wideband reads 10.0,i checked all the clamps and they are good.i also have a log at idle.for some reason when it was at...
ok so ive replaced this fuse at least 10 times already
when i replace the fuse both wipers (front and rear) work properly
but when i press the stick for the water to come out thats when the fuse pops
please help me guys
i just installed my wideband and it reads 10.0 at idle and 14.9 to 15.6 when cruising
02 sensor on downpipe
wideband not loged w/ dsmlink
should i log it with dsmlink?
If anyone can install the following in my car.
-aem tru boost
-aem wideband
i would also need to setup speed density and tune with dsmlink v3
i have the sd budle that came with dsmlink
please pm me or email me at [email protected]
i live in fords nj 08863 near woodbridge and edison...
im getting dsmlink v3what do i need to run speed densitydo i need to get
- SD bundle (MAP, IAT, pigtails and bung)
or
-sd cableor maybe boTHALL FROM ECM TUNINGthanks
my wipers fuse keeps blowing up after i replace them
3 times already
relay is good
when i replace the fuse and turn the wiper switch i hear the fuse pop
i dont know what it could be
what should i check for
both front and rear wipers dont work
my goal is awhp 350 dd-dsm link v3 or v3 lite???
-aem tru boost
-aem wideband
-evo big 16g
-spearco fmic with tial 50mm bov (i already have it but idk when to install it before or after i get all the other parts)here is what i have installed already
-all new belts
-oem clutch...
i just bought a a spearco fmic with a tial q bovwhat do i need for my car to run properlywhats on the car right now
-8.5 mag wires
-injen intake pipe w air filter
-n1 exhaust
-xs bov vented
-act 2600
-act flywheel
-b&m short shifteri want to know if a need to upgrade my...
the car was ok before this the only problem was that when i switch gears the rpms will drop to 0 and the car would shut off....but now it wont even start....it only does when i press the gas pedal but the motor sounds really bad.....and when i let go the gas the car shuts offi thought it...
it was... they told me everything that they did to the cari cant find any leaksi do i think is normal for a act 2600i didnt have a chance to call them yet but will tomorrow
now
when the car is off i can go to every gear 1-5
but when tha car is on and try to shift gears it start...
i took my car to turbotrix
replaced the following
-transmission and t case from engine depot(mine was messed up)
-act 2600
-act flywheel
-clutch fork and ball
-all the belts and water pump
i drove it home with no problems maybe 10 miles
i left it in my drive way for a week then decided...