The Top DSM Community on the Web

For 1990-1999 Mitsubishi Eclipse, Eagle Talon, Plymouth Laser, and Galant VR-4 Owners. Log in to remove most ads.

Please Support Rix Racing
Please Support Fuel Injector Clinic

2G fuel pump question

This site may earn a commission from merchant
affiliate links, including eBay, Amazon, and others.

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

stiggity99

10+ Year Contributor
231
4
Mar 31, 2011
York Haven, Pennsylvania
i replaced my fuel pump assembly, fuel pump, and ran -6an from pump to rail. i also pulled the drivers side float and syphon pump, awaiting it's replacement to arrive soon. is it possible to start the car with no drivers-side assembly present? all i want to do is turn the pump on via dsmlink, and flush out anything in the supply line, b4 i connect the filter. Thanks
 
Last edited:
Should be able to cycle to key to have the pump turn on withbout actually firing the car if you unhook the lines from the rail you could do a flush threw it

Correction, cycling the key will only work if your pump is hard wired / rewired
 
Correction, cycling the key will only work if your pump is hard wired / rewired
You are incorrect on both counts. Pump only turns on with motor spinning. If you rewired and used a key on 12v source to trip the relay then yes you are correct. Most people use the stock fuel pump wire to trigger the relay and that does not have 12v with just key on.
 
Support Vendors who Support the DSM Community
Boosted Fabrication ECM Tuning ExtremePSI Fuel Injector Clinic Innovation Products Jacks Transmissions JNZ Tuning Kiggly Racing Morrison Fabrications MyMitsubishiStore.com RixRacing RockAuto RTM Racing STM Tuned

Latest posts

Build Thread Updates

Vendor Updates

Latest Classifieds

Back
Top