mac 108
15+ Year Contributor
- 216
- 3
- Feb 15, 2005
-
Memphis,
Tennessee
Doing the 1G AWD factory big brake 2 piston caliper swap on my 90 AWD.
Using NT 3000GT brake calipers and JNZ Tuning stainless steel brake lines.
The problem is that the banjo bolt to connect the lines to the caliper is too tall. Where can I find a shorter one? Can't seem to find one on any of the parts store sites.
I would assume that it would be a bad idea to stack additional crush washers to make up the size difference.
Is this bolt too long because I used NT 3000GT calipers over 93/94 AWD DSM calipers?
Using NT 3000GT brake calipers and JNZ Tuning stainless steel brake lines.
The problem is that the banjo bolt to connect the lines to the caliper is too tall. Where can I find a shorter one? Can't seem to find one on any of the parts store sites.
I would assume that it would be a bad idea to stack additional crush washers to make up the size difference.
Is this bolt too long because I used NT 3000GT calipers over 93/94 AWD DSM calipers?
You must be logged in to view this image or video.