eclipse012
15+ Year Contributor
- 183
- 10
- Apr 17, 2008
-
canada,
AB_Canada
Going to be taking my throttle body off tomorrow to swap out the shaft seals as they are keeping my throttle open a bit too much and not dropping my idle down to where it should be.
I'm looking for some help on how to use evoscan to adjust the TPS to make sure its sitting back at .63volts again when I screw it back on.
As of right now evoscan says my cars TP is 13.333 at idle.
How do I log voltage on the TPS? I can't locate anything else on evoscan.
Or is there a formula that you can use 13.333 against that will = X volts?
I'm looking for some help on how to use evoscan to adjust the TPS to make sure its sitting back at .63volts again when I screw it back on.
As of right now evoscan says my cars TP is 13.333 at idle.
How do I log voltage on the TPS? I can't locate anything else on evoscan.
Or is there a formula that you can use 13.333 against that will = X volts?
Last edited by a moderator: