Dsmturbo
Proven Member
- 56
- 8
- Jan 20, 2015
-
SoCal,
California
Awesome project, love sleepers!
Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature currently requires accessing the site using the built-in Safari browser.
This site may earn a commission from merchant
affiliate links, including eBay, Amazon, and others.
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
your going to have to make a hybrid wiring harness out of the 4g64 harness and the 2g 4g63 harness. Most of the harness will be 4g63 wires, but there are a few 4g64 wire that gotta stay. I wish i would have documented how i did it, just to blueprint out how i did the wiring for my own knowledge... Whoops.
The temp sensor mod i did was i took out the vacuum thermo switch that is located on the 1g lower thermostat housing. Then I replaced it with the thermo sensor that is located at the bottom of the radiator. I extended the wires and plugged it back in and it made the fan activate at a lower temperature, as the rad fan activating sensor is now located in a hotter part of the cooling system.
. When my auto project is done I am going to be tempted to do an evo9 mivec drivetrain swap version of one to replace my evo 1.
yes one of these with evo 9 drivetrain would be amazing. The evo uses 3.3 ratio rear. so the rear end can be made to work pretty easy. would just need to be flipped upside down. that would switch offset to passenger side engine setup. I would use evo 4 engine and trans swap. then use the evo 9 head. wala. ultimate RVRIf I understand this correctly, you plan to put a evo 9 motor and drivetrain setup in a Expo LRV? Why not!!