onefast2gdsm
10+ Year Contributor
- 866
- 6
- Aug 30, 2010
-
millersburg,
Pennsylvania
I just swapped a 03 lancer ecu in my 1g dsm flashed with tephramods v7 with 3d ve table sd. I have pte 1200 injectors and theyre scaled.
Im having issues with the car revving to 4k at idle with the stock ve table. If I lower the ve in the idle cells the car idle surges from 1k to 1500 rpm. Cruising is lean 16:1 but its smooth.
I adjusted the ignition timing
I adjusted the tps as it was way off
No boost leaks
Changed the map scaling to 1:1 and set it to a gm3bar
I messed with the isc tables a little bit but didnt really notice a change.
Anyone have any ideas of what would cause this? And ia there a "simple" way of building the ve table? I have a 2g maf but dont really want to go through the hassle of changing my setup to run it.
The mods on the csr are:
Hks 272 regrinds
Holset hx35
Pte 1200 injectors
Gm 3 bar
Gm iat sensor
Punishment fmic
03 lancer ecu flashed with tephra v7 sd
Afpr
300lph pump
Etc
Im having issues with the car revving to 4k at idle with the stock ve table. If I lower the ve in the idle cells the car idle surges from 1k to 1500 rpm. Cruising is lean 16:1 but its smooth.
I adjusted the ignition timing
I adjusted the tps as it was way off
No boost leaks
Changed the map scaling to 1:1 and set it to a gm3bar
I messed with the isc tables a little bit but didnt really notice a change.
Anyone have any ideas of what would cause this? And ia there a "simple" way of building the ve table? I have a 2g maf but dont really want to go through the hassle of changing my setup to run it.
The mods on the csr are:
Hks 272 regrinds
Holset hx35
Pte 1200 injectors
Gm 3 bar
Gm iat sensor
Punishment fmic
03 lancer ecu flashed with tephra v7 sd
Afpr
300lph pump
Etc