azules demon
Probationary Member
- 18
- 0
- May 23, 2013
-
san diego,
California
Alright since im not quite sure where to Post this i hope it geta the right attention. I have a 1ga That finnally tuns over but wont start. Current mods 2.3l stroker. Wally 255 with 6 an fuel line to rail with regulator. Ecm link SD( 4 bar omni and gm iat). FIC 1450 cc injectors. Battery relocated to back with proper disconnect and breaker and grounding setup. Pte cea turbo. GM alternator mod. fuel pump has a switch and it Has proper hotwiring. aem u
eugo, boost, and coolant teml gauge installed. Wideband is tapped into 5v source on main harness. No a/c. or power steering.
ive been doing some reading and saturated injectors are high z yet my fic say saturateD with resistor pack (newbie question) i do not hear the injectors click at all or even spray when i had the plugs pulled off to inspect the cylinders for smell of fuel. The harness has been shortened due to to much excess wiring and i has the wires shortened one by one so i didnt confuse any of them. Ive checked the resistor pack plug (5 pins) and the iac ( 6 pins) pluged into right place. After i have turned the car over i hear an odd clicking sound, revirberating from the CAS. I have dsm link but am also unable to connect but on a random occassion ( bad cable or ecu?)
I checked fuel and its good still burns.
Is there anything im missing? Or not looking at
eugo, boost, and coolant teml gauge installed. Wideband is tapped into 5v source on main harness. No a/c. or power steering.
ive been doing some reading and saturated injectors are high z yet my fic say saturateD with resistor pack (newbie question) i do not hear the injectors click at all or even spray when i had the plugs pulled off to inspect the cylinders for smell of fuel. The harness has been shortened due to to much excess wiring and i has the wires shortened one by one so i didnt confuse any of them. Ive checked the resistor pack plug (5 pins) and the iac ( 6 pins) pluged into right place. After i have turned the car over i hear an odd clicking sound, revirberating from the CAS. I have dsm link but am also unable to connect but on a random occassion ( bad cable or ecu?)
I checked fuel and its good still burns.
Is there anything im missing? Or not looking at