The Top DSM Community on the Web

For 1990-1999 Mitsubishi Eclipse, Eagle Talon, Plymouth Laser, and Galant VR-4 Owners. Log in to remove most ads.

Please Support STM Tuned
Please Support Morrison Fabrication

For you Holset guys, JNZ has the N/T Water Pipe in stock!

This site may earn a commission from merchant
affiliate links, including eBay, Amazon, and others.

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

Oh nice! Wish I found this when I had everything apart. I have coolant caps on them ports now, But if everything comes out again I'll be switching to the N/T pipe for sure.
 
Oh nice! Wish I found this when I had everything apart. I have coolant caps on them ports now, But if everything comes out again I'll be switching to the N/T pipe for sure.

Just weld the ports closed. I had mine welded closed. Worst case scenario, use JB weld.
 
JB weld would hold the water pressure at 200 degrees??
 
I jb welded a bolt in ahose and clamped both to the barb. Been fine here for all kinds of hot temps.

I had something similar before I welded it up. Machine screw in a hose with high temp silicone and a ring clamp. No leaks, but it looked ugly. So when I pulled the motor I also cut the water pipe nipples (leaving about 1/4 inch) and welded them shut. Sprayed the whole pipe with some paint and Bob's you uncle.

You must be logged in to view this image or video.


You must be logged in to view this image or video.
 
Support Vendors who Support the DSM Community
Boosted Fabrication ECM Tuning ExtremePSI Fuel Injector Clinic Innovation Products Jacks Transmissions JNZ Tuning Kiggly Racing Morrison Fabrications MyMitsubishiStore.com RixRacing RockAuto RTM Racing STM Tuned

Latest posts

Build Thread Updates

Vendor Updates

Latest Classifieds

Back
Top