http://www.dsmtuners.com/forums/420a-bolt-tech/343318-help-tokico-blue-suspension-kit-fwd.html

http://www.dsmtuners.com/forums/handling-tech/294833-eibach-prokit-springs-softer-than-stock.html

http://www.dsmtuners.com/forums/handling-tech/213963-spring-rates.html

Those are a few good threads on the subject

Breakdown:

Tokico spring rate = 285/160 lbs/in
Eibach-Pro spring rate = 267/154 lbs/in (Progressive Springs so average was used)
2gb FWD OEM spring rate = 246/151 lbs/in

According to the threads, you won't need a camber kit for the front, just the rear. They will most likely have that at the alignment shop, or you can just use washers, so that should save you some money in that department.

As to which springs are better, probably the eibachs, but I would doubt you would notice a huge difference between the two. That kit will serve you just fine if you are looking mainly to lower your car and stiffen up your suspension a bit for a daily driven or street driven vehicle.

The best combo for handling, ride, and money for under 2k though, will always be the koni/ground control, just fyi.

http://www.dsmtuners.com/forums/handling-tech/416132-best-street-springs-shocks.html

I'm also looking for a good shock/spring combo. My car is currently lowered and the front shocks have definitely given out, bumps up and down like crazy anytime I hit a bump in the road; I wanna raise it back up to the factory height due to the terrible road conditions here in VA. I wanna go with the koni/ground control combo, it there anything else I should look into?