I have a 2g Eprom ecu, and an inspected, working 1g awd trans. Looking for $175 for the ecu, and $400 for the trans.

I also have tons of other dsm parts. 1g nt long tube headers, brackets, O2 housings, etc. lots of small stuff I just give away.

Here's my list of items I am looking for....
- OEM particle board mitsu used in the back of the AWD 1g's
- plastic clips to secure the particle board
- Rear speaker grills, fabric condition not important
- Heat shield that goes underside of the hood
- TDo5 V-band clamp

donniekak said:

I have a 2g Eprom ecu, and an inspected, working 1g awd trans. Looking for $175 for the ecu, and $400 for the trans.

I also have tons of other dsm parts. 1g nt long tube headers, brackets, O2 housings, etc. lots of small stuff I just give away.

Click to expand...

Still have the auto awd 1ga tranny? Willing to ship?

EclipseGS-92 said:

Still have the auto awd 1ga tranny? Willing to ship?

Click to expand...

I don't have the auto now, this trans is a manual. I can get a 1g auto trans, but they aren't real cheap.

Maybe I missed it but what is the spline count on the trans?

13b Bro said:

Maybe I missed it but what is the spline count on the trans?

Click to expand...

23, but I can install a 22 if that is what you need.

Did you receive my PM?

Yeah, I need to hear back from one other person. This is my only backup trans at the time.

Just wanted to reply and say I've dealt with donniekak on multiple occasions he has fixed my DSM when Mark Mitsubishi couldn't.

I would not hesitate to deal with donniekak again!

You don't happen to have an extra intermediate half shaft laying around that you can get rid of? I need it for my 5 spd 92 Talon. Apparently the one I have is not for this transmission.

I believe I do, but I'd have to see the gears you have in there to make sure.

Oh alright, I'll try and snap a picture but the transmission is already in the car.

Oh, are you talking about the shaft that bolts to the back of the block?

Would you be able to figure it out with transmission number incase I can't get a good picture?

donniekak said:

Oh, are you talking about the shaft that bolts to the back of the block?

Click to expand...

Yeah that one

Do you have the ac compressor bracket on the car?

donniekak said:

Do you have the ac compressor bracket on the car?

Click to expand...

Yes I do

Take a pic of how its lining up.

donniekak said:

Take a pic of how its lining up.

Click to expand...

It actually lines up good, it's inside the transmission where is loose. It has a lot of play

I'd have to look at it. You may have bad diff bearings in the trans.

donniekak said:

I'd have to look at it. You may have bad diff bearings in the trans.

Click to expand...

Ahh no kidding? Just what I need