Midwest2gb
Probationary Member
- 8
- 0
- Jul 14, 2014
-
Northwest,
Indiana
Howdy all.
I've got my 2gb Talon project on the road for the first time since starting the project last December.
I've finally gotten the idle dialed in, amongst other things. Runs and drives great while in vacuum and low boost (>5 psi). When the ECU sees anything over that, it breaks up and loses all power.
Can't seem to figure out what is causing this, though I'm sure it is fuel related. This is my first venture into datalogging/tuning, and am in need of some assistance to say the least.
Mods are as follows :
-6 bolt block
-2G head, stock cams, early 1g CAS
-TD05H E316G, E3 exhaust mani and 02. 2G IM & TB
-Ngk wires, br7es @ .028
-Wally 255, FIC 1450s, AEM afpr
-Link v3 full running on SD via omni 4 bar and GM IAT.
-UEGO WB set as linear WB ecu input
-
I've got my 2gb Talon project on the road for the first time since starting the project last December.
I've finally gotten the idle dialed in, amongst other things. Runs and drives great while in vacuum and low boost (>5 psi). When the ECU sees anything over that, it breaks up and loses all power.
Can't seem to figure out what is causing this, though I'm sure it is fuel related. This is my first venture into datalogging/tuning, and am in need of some assistance to say the least.
Mods are as follows :
-6 bolt block
-2G head, stock cams, early 1g CAS
-TD05H E316G, E3 exhaust mani and 02. 2G IM & TB
-Ngk wires, br7es @ .028
-Wally 255, FIC 1450s, AEM afpr
-Link v3 full running on SD via omni 4 bar and GM IAT.
-UEGO WB set as linear WB ecu input
-