kneipperk
10+ Year Contributor
- 214
- 1
- Oct 25, 2009
-
aurora,
Colorado
So i'm finally getting around to putting together this 1st gen that I tore apart like 4 years ago. Talk about a brain fart. Sure hope I got it all the right way HA! Everything is going smooth. Pretty much stock. Got the head rebuilt from a local machinist. Honed the block. All new gaskets and seals. New pistons and rings. Balance shaft elimination. New head bolts. New waterpump etc etc... Everything was so caked in oil and from leaks so I used the solvent tank and just about everything that i could. Now that everything is BLINGING i'm having a hard time remembering where little bits and pieces go. Before it wasnt so bad, I could tell by the oil stains where everything went haha. Now im just waiting for my Gates timing belt and tensioner to be delivered and I will install that and be ready to drop the engine in. Just want to make sure I got everything in place before pulling the pin. Long story short, does anybody know where this guy goes?
You must be logged in to view this image or video.