jbeaton9292
Proven Member
- 847
- 72
- Aug 29, 2013
-
Sterling heights,
Michigan
Ok so i decided to try and make my own vent gauge pod for my wideband and boost gauge i used the vfaq to see how its been done gave me a idea of how to go about it
So what i did is took my old 1g a pillar dual pod and cut the gauge holders off angled them by running the on side of fiber cutoff wheel the glued them where i wanted them to vent bezel (hot glue) then i pull nylon leggings over it and glued it down where i needed to hold it all in place (after streched tight) then i used the fiberglass resin kit from walmart 17$ comes with resin hardener spreader stir stick fiberglass cloth (stuff stinks sobad ) and just slapped on a quick layer on the nylon so it will harden and add more so it cantleak through the nylon thats as far as ive made it so far pics attached
So what i did is took my old 1g a pillar dual pod and cut the gauge holders off angled them by running the on side of fiber cutoff wheel the glued them where i wanted them to vent bezel (hot glue) then i pull nylon leggings over it and glued it down where i needed to hold it all in place (after streched tight) then i used the fiberglass resin kit from walmart 17$ comes with resin hardener spreader stir stick fiberglass cloth (stuff stinks sobad ) and just slapped on a quick layer on the nylon so it will harden and add more so it cantleak through the nylon thats as far as ive made it so far pics attached