Still a great deal on Feal Coilovers.

Good deal on Coilovers

Prices changed

Prices Changed

Sadly, I once again have to part out my car since life isn’t going how it should.95’ ECU w/ECMLink v3 with cable $625 shipped/pp fees SOLDBuilt 6Bolt short block bought from RixRacing It is bored .040 over with .040 Wiseco pistons and Eagle H Beam rods $1500 this short block is ready for a...

Well time to break the bad news. I did the compression test and cylinder 2 was at 90. So, I did a wet test and it came up to 125. I meant to post this yesterday. I will be going to pick up a built short block tomorrow.

I appreciate the kind words Kryndon. I removed the catch can and my PCV line and breather line are back to stock. I wouldn’t tear into the turbo if it comes to it I’ll ship it to Justin and see if he sees anything. Honestly, I will only know more with a compression test which I did right after I...

Sorry haven’t updated in a few days. I got super discouraged by this whole ordeal after dumping so much money into the car. Also before reading below, I want to note that the car has not ran for almost 3 years. I did put it together at the end of 2017 and idled it a handful of time in which I...

Well, my catch can had a check valve pointed in the wrong direction and my PCV line had a check valve pointed in the wrong direction which ended up pushing air into the crank case and letting 0 pressure out....I was dumb very very dumb and excited and just threw the lines on without checking...

So, I had an issue with the PCV routing the first time I started the car and had entirely too much crank case pressure. It ran 20 seconds according to ecmlink. At this point I’m starting to think that 20 seconds was long enough to screw the seal on the turbine side. And I completely agree that...

I know where the oil is coming from. I never said I didn’t know where the oil is coming from. And 1990TSI you are correct about there being a crush washer on the fitting that goes into the turbo. I had been awake like 30 hours. My issue is there is oil being pushed past the turbine side seal...

It is 4an feed line from OFH so no crush washers. It was just rebuilt and literally has 3-4min of idle time on it. What I haven’t checked and feel dumb for now is oil pressure. So, I will be going to auto parts store for a gauge and install kit tomorrow.

Alright I am calling all gurus for this. I have talked with JusMX already and we both aren’t sure what’s going on. My old school green is slowly leaking during idle(see attached picture). I fixed my PCV system back to stock. I pulled the drain line and there aren’t any kinks or blockages in the...

New Update! Wish I would have taken more picture. To start, I pulled the transmission because the last time I had the car running I was having disengagement issues. So, I replaced the beat up Fidanza flywheel with an OEM 6-bolt flywheel after having it resurfaced and the step height checked and...

Sounds super vague honestly. My opinion is that turbo seals are shot as you shouldn’t have “manageable” oil passing out of the turbo. I would ask him to do a compression test as well as a list of what mods that are on it. Sounds like fuel parts were upgraded without using any tuning software...