@1cleangsx thanks so much for the help!

Thanks for the response guys :D I think you’re right 1cleangsx. It’s the wire that bolts to the 80 amp fuse and runs to the battery terminal ? Do you have a pic of it by Chance ?!

Hey guys. Have one last piece of the wire tuck I just finished but can’t for the life of me remember where this went. Haynes manual doesn’t mention it and I can’t find any pictures on the site. From the terminal at one end it appears to go on the battery terminal or the engine bay fuse block...

That is exactly right ! Thank you sir. I remember now

A few months ago I had removed my harness and can’t for the life of me figure out where this terminal goes. It’s a 1990 eagle talon tsi awd I ’ve searched and searched and can’t find it in any of the 1990 harness write ups. It’s very close to the fuse box.

Hey guys! I have some parts that came off of my old 1g that are just laying around. They came off a running 90 eagle talon tsi awd. They have about 3000 Kms on them. Fidanza v2 clutch about 75% material on the puck. Some light cracks on the pads but I never had problems with the clutch. Some...

Hey guys, I'm having an issue finding a noise that's starting to to drive me crazy.The noise is coming from the timing belt area. It's kind of a supercharger whine. I found some write ups about the same sound on 90's. Apparently it's due to straight cut gears in the oil pump. Unfortunately I...

No reason in particular. It's already installed. Just was hoping to keep everything as is if it just meant running one wire. Is there any added benefit to simulating it as the o2 sensor in narrowband.

Hey thanks for the replies guys. Yes it is a 1g. So because my egr sensor is not in use I can run my white wire to pin 15 and input it to log my wideband?

Hey guys, I've searched quite a bit and haven't found any thing that really answers my question. Either that or I'm not understanding it fully. I want to be able to log my aem wideband through ecmlink. But I don't want my wideband to replace or simulate my factory o2 sensor. Do I just splice the...

Ahhh I see your last paragraph makes sense now. And thanks for the step by step gst with psi. I'm kind of doubting the cams were degreed when I had it built. Is it possible to degree them with the engine in the car or is it just too tight?

Thanks for the reply guys. so hypothetically speaking I have Manley pistons and eagle rods, 280 bc cams and their valves retainers etc, if I was to check valve clearance on a stand with clay, their would be a possibility that if a camshaft was degreed 1 in the advance direction that it could...

Hey guys. I'm looking at adjusting my cam gears a little. Cams were installed straight up at 0 tdc on the crank. Am I safe to adjust the cam gears 2^ retard or advance without a degreeing wheel on the crank. I've done some research and from what I understand they can be adjusted on the gears a...

Thanks 19eclipse90 !!! That's perfect

Hey guys! I'm having difficulty trying to piece together my cruise control box.... I've searched for a couple of hours and I'm sorry if this has been answered before but, I have no idea how these brackets go on the cruise control box. Any help is appreciated.Car is a 1990 eagle talon TSI AWD