Seeing if anyone can help me figure out some parts brands
Exhaust are both off a 2g, one is fwd the other is awd, both seem pretty well madeIntercooler is a 1g short route core
I did top middle bottom with the dial bore gauge (followed the jafro video) I did not have any significant taper. my measurements where 84.95- 84.94. I used the original piston as a square, and went down to the 3 ring grove. I did it over and over to double check. I seen spec called for up to...
im rebuilding a 6 bolt motor and am using a set of npr piston rings with the stock pistons. I dial bored my cylinders and got a very constant 84.94-.95 on all the cylinders. I ran a 240grit flex hone a few times, until the walls looked fresh and the carbon build up was gone off the top of the...
I looked around on rockauto and a few other sites for them and cant find them. The actual spring seat is rusty but i can always wire brush that and repaint if I cant find a replacement but I also cant find the rubber ring that does between the spring and the seat. I noticed that the 3g and evo...
Eh im not up for a tear down with a few other cars apart as well at the moment. I was hoping there might be some thing else I could check real fast before giving up on it
Let me start off by saying the car has sat since about 2008
I bought it a few months back after the PO let it sit for over a decade, essentially he throw a bunch of aftermarket parts (cams, injectors, intake mani turbo ect) and never got it to run right, so he claims. On top of that there was...
Noticed on link my brothers front o2 is not getting a signal. Initially I thought it was a bad sensor, until I noticed some tape around the harness side of the plug. The 4 wires look fine but I noticed a bare wire that seems to wrap around them all? What is that for or from?* we are...