Hello
I am looking for ecmlink V3 eprom with cable.. (pls notice not lite version).if it possible with SD version it would be better I mean IAT and map sensor..Please write your price not brand new price.I can only pay via Paypal with good and...
thanks for response I was doubting about convertible ecu but I did research it s not..if you look at pictures you will see that..so your opinion is adding a a crank sensor ? if it s, I don t think I will do it:) I wish I bought a evo ecu I never...
The 1G CAS is able to provide the correct signals to run the engine on a 97-99 ECU, but you have to wire in the inputs from it to the ECU separately for the crank position sensor and cam position sensor to provide the signal to the right ECU...
I am searching article on this forum @steve I read the steve's articles I think Ecu can not get pulse from CAS and it s dying. I have green top CAS.. By the way I bought brand new black top CAS also I am waiting it. if ECU gets pulse from CAS...
i was thinking about same thing. Can i do from fuel pump check connector? By the way i am doubting about pin 13. it s free now Do i have to connect it to somewhere?
i am not sure but i found article about convertible ecu fuel pump. it does not look like my issue. some transistors removed on this ecu for fuel pump problem. I bought blackbox ecu maybe problem is that. I have green top CAS..
Has anyone been able to run a 1999 ecu on a 1990 dsm or what should I do? Even though there is a patch harness, the car starts and then stops immediately. My vehicle is a 1990 AWD. I wrote to a few forums but no one answers because it's an old...
i have a question pls someone help me?. I did everything as you shared the pinouts on my 1G with H8 ecu but it stars and it dies within 3 seconds. I hear a tick sound from MPI relay then car stops(
The ecu needs the signal from the crank sensor. Whether there is an adapter harness or a way to feed it what it needs I’m not sure but I’m fairly confident that’s your issue.If you have Ceddy you can see if there is an option to run the fuel...
thank you I wish I could run it. i have socketed ecu also i think i will find ecmlink..Really sick and tired . I wasted my time..I hate myself sometimes but it would better to see car runing..I followed the this pinout instructions..
But when i plug the 1G ecu it works very well..Something is wrong but where is it:) I hear tick sound from mpi relay then car stops..it works very well until to 3 seconds..By the way I did not replaced 2G knock sensor..I don t think it would be...
Hello guys i know some people can say something about my decision but i want to end up this process i have 2G ecu (1999) in my 1G. my problem is about dying after start. Car is cranking and starting after 3 seconds I hear click sound from MPI...
I wanted to try a fantasy :) and I wanted to try the 2g black box 1999 model (MD359402) ecu over the 1G awd 1990. There is a lot of mixed information on the internet. I didn't know which pinouts to use. I plugged the converter to car and it...