If all drives ok after your rebuild, I would check something easy and maybe a coincidence unrelated to suspension. Check you power steering fluid level.
Did you check your master cylinder. I recently upgraded my clutch to comp 3 and the clutch would work for a short time then suddenly not have enough pressure to get into gear. Once I replaced the master cylinder all was good.
Hey all,I sent Brian a message about the Koni damping setting and he just responded.. So I decided post back here on what he told me. This may help everyone.He said that he set them 1/2 to 3/4 from firm for all four shocks and that provides a great ride and still firm enough for...
OK, let us know what you come up with. My shocks were already dyno'd... so I'm assuming that is for compression only. But, when I tested the two side by side the rebound damping was way off. So, I set them both the same "guessing" and put them back together. What was strange is a half turn...
Nice DG setup, What was your spring rate and koni damping setting. I just got mine built and shipped to me. 600F/300R im not sure what to set the damping setting to for the F/R for koni yellow shocks. What do you set to and how does it ride.
I had a cam sensor go bad. Symptoms: start run fine and then started to do some (minor) strange erratic power thrusts when on throttle it would come and go. Then finally check engine came on. One night I decided to turn car off/on at a light. It wouldn't to start just turned over. waited 5...
That looks nice, Are your pics with the 1.3" drop all around. I do like that a lot. Did they have to do any fabricating to get the yellows to work with Pro Kit?All,Sorry for my ignorance but, is this even possible. I was looking at my front suspension last night and it appears that you...
So whats the best setup. What is GC (Ground Control) is that a special type of spring different from Eibach Pro Kit spring? I'm also worried about the pivot problem with non-stock like coilovers (mentioned in Dennis Grant (DG) write up).
Sweet thanks for the Pic. Do you think I could get away with 45mm offset on all 4 tires with 235/40R18 instead of 40mm? My stock is 17x6.5 46mm 215/50 and I have about barely 5mm on the back between arm and the tire front has plenty. So maybe 45mm in front and 40mm in back? Any issues with...
I got 1997 GSX (One owner me). Love this car!!! Finally I found some rims that are better than stock and look almost stock (Enkei PF01). I think I want to put 235/40R18 w/ 18x8 40mm offset not sure. Everyone always goes with 225. The rear view is important don't want a wide gap look between...