Forced Performance Race Manifold - $120
Going to T3 setup no longer need, no cracks, great condition. I can throw in head and turbo side gaskets.FIC 125-550 550cc injectors - $80
Unknown miles, worked perfect when pulled. Went to 1050cc, don't need. Needs seals, then run.
Just put the egt probe in the downpipe after the o2 housing you will still get plenty accurate readings and if you decide to swap manifolds again, it will still work.
Thanks for all the help guys!Its a 6bolt.I'll check the balancer didn't think of that. It's got the green top cam sensor, i also have a black top laying around. base timing is set at 5degrees btdc.
I think your right! manley turbo tuffI always run shell 92oct, im running a small 16g, and i've been adjusting the timing with ecmlink, right now in the high end where it knocks the most, im running -3degrees of timing so that shows how bad the problem is.When i run 110oct i can run up...
I popped the oil pan off my car to see if I could diagnose why I am unable to make any power with out knocking. I bought the car with a mystery motor and im trying to unmask this short block, I was told it had "some" rods and wiseco pistons.What rods and are these in fact wiseco's?
this exact thing happened to me when i first got my talon, for me it was that the SAFC that was spliced into the maf sensor wire right at the ecu as disconnected. so basically it acted like it had no maf sensor data at all.might check that.
:aha:Ebay doesn't make the clutch kit, XTD does, I haven't had the best luck with my xtd stage 4 unsprung, but its the only thing that can hold ~400hp/torque for under $350.its not always true that you get what you pay for, act isn't perfect either throwing springs and all. But the...
have you changed how the vacuum is run with the new turbo? This is similar to what happened to me when my wastegate and the bov Tee-d off the same vac line.Nevermind I see that you fixed your issue! good luck.