Please Support Miller Import Parts
kdubbs
Last Activity:
Oct 17, 2017 at 7:34 AM
Joined:
Aug 14, 2012
Posts:
5
Likes Received:
2

Share This Page

kdubbs

Probationary Member

kdubbs was last seen:
Oct 17, 2017 at 7:34 AM
    1. kdubbs
      kdubbs
      I currently have my 6 bolt block at the machine shop being built. It is .040 over with Mahle stroker (4032) pistons, eagle rods and 100mm eagle crank. I bought the block used already bored to .040 over. The shop honed the block and told me that there is a little out-of-roundness towards the bottom of the cylinder (last inch or so) that measure 0.0005". I know the spec is 0.0004" for the turbo blocks but if the rings will never see it will it be ok? The shop said it would be and if the rings did touch some of the out of roundness it would be lower like 0.0003". I would get a new block but wont because of money and the current situation so its not worth asking. Any suggestions would be helpful. The only changes I will be making are a new SBR G50 and shooting for 400-450 whp.


      -Thanks, Kevin
  • Loading...
  • Loading...
  • Loading...
  • About

    City:
    Marin
    State:
    California


Log in/Register to remove ads

Support Vendors who Support the DSM Community
Ace Race Parts Advanced Fuel Injection Archer Fabrication Boostin Performance ECM Tuning Extreme Turbo Systems ExtremePSI Feal Suspension Fuel Injector Clinic Jacks Transmissions Jackson Auto Machine JNZ Tuning Magnus Motorsports Miller Import Parts Morrison Fabrication & Design OHM Racing Race Components Inc RockAuto RoadSurge Spultronix Performance STM Tuned Strictly Import Motorsports VR Speed Factory