If it points downward and connects directly to the lower rad hose, it's a 1G water pipe and thermostat housing. If it points upward and mates with a rubber oring to the thermostat housing it's a 2g configuration.

I feel like a few terms need to clarified here. 7 bolt can refer to both 1g and 2g engines. Doesn't really matter for this discussion but should be noted. 1g head can also be 6 bolt and 7 bolt. You didn't specify but also doesn't really matter in...

I put together a spreadsheet and posted it on this forum. It was based on an accumulation of weights I had taken on an industrial precision scale. It was fairly incomplete, but it was the facts as I measured.Points to anyone who can find the...

To remove: 1. Remove the 2 nuts holding it on. 2. Unplug harness from CAS. 3. Slide off studs.To install: 1. Set engine to TDC. Do this by rotating the crank pulley CLOCKWISE until the cam gear timing marks are lined up. You can check if...

the 2 water fitting that come with the WG 2 90* 4an lock tite fittings 2 brass 1/4 inch to 3/8 fittling (3/8 is very snug) 4ft 1/4 coolent hose 1ft 3/8 coolent hose (again 3/8 had me spitting fire)I HAVE THIS LABELED BACKWARDS...