Joey Burger submitted a new DSM Profile :96 Eclipse GSTRead more about this vehicle here...

Joey Burger submitted a new DSM Profile :1995 Eclipse GSXRead more about this vehicle here...

and how to i count the pins?

i dont have a trasmission control module though. does that make a diffrence??

To specify there is no CEL. So i know im not getting power.

Long story short had wires short in my car. Finally said screw it im done wire fishing and im going to run my own relays. Need to know what wires turn on my ecu to trigger it to turn on. Searched for the last day and a a half on how to do it. help much appreciated!!!

Alright long story short bought 2 shitty dsms one runs good but has lots of rust other is a shell. One is a 1998 eagle talon esi manual trans, other is a 97 eclipse rs automatic same motors. Different trans. What all involves swapping the eagle talon motor and trans into the eclipse? Can i lift...

Theyre all cut with no metal showing though. And all my electronics still work. I can read my codes aswell. Thats why im shocked at it not firing

While i was under my car however i noticed that my o2 sensor wires were cut. Could this cause the car not to start??? Im still new to all the electrical stuff.

I changed my cam already. I also went and got a brand new crank sensor. Didnt change a thing. What should i check next? Im really confused...

Ok, and yes. The fuel pump dosent come on and there is no spark should i go get a crank sensor?

Also tried resetting ecu. Battery method and code reader method. Only gives me a bad relay for low speed fan control when i run the codes.

Alright, changed my cam angle sensor to one i had in my eclipse. Still nothing. Try resetting my ecu?