No offence, but are you forming your opinion that its overrated and we are hyping it up on the v6 magazine article (that you dont trust anyway)? I can tell you I sat in one. Started it and drove it around the lot. Fit and finish is very nice and it shifts (at least 1st through 3rd anyway)...
Hyundai/Eagle/Jeep tech. Moved into parts a while back after an injury. Been with the same shop for 17 years. I would buy a Ford over a GM any day. I deal with the recon (used car) dept. too. Pound for pound we have more newer Gm's coming back than Fords. Keep in mind I drive a Chevy 1500 so I...
Hot off the truck :thumb:
41 city 36 hwy 32kDigital dash that does some cool things. There is a tree that grows on the right when you are saving fuel :hmm:
[Didn't you even say yourself that you had to have your transmission replaced in YOUR Hyundai????My DSM is 12 years old with 130,000 miles...still stock tranny.My Jeep has 201,000 miles and still stock auto tranny...yet Chrysler is the one with a bad name for their Trannies. WHY?So...
Subaru and toyota joined forces and rumor has it they are building a performance coupe. Subies AWD, and it being a 6 speed coupe is all that is confirmed at this point. They said they hope it to be 3000lbs or less. could be a beast
OnlineYea,but how much will it cost? There are...
I would not think twice about getting one. 10year/100,000 warranty. The car is slick for sure. I hate the grille too but the aftermarket will take care of that :pray:
I laugh at anyone that says "I will never buy a Hyundai" man they are missing out..
They had some trans problems in the late...
My seat sticks out about 1/16.
It seals the wg (no gaskets needed) aginst the flange.
I have the older (non hp or v-band ) tial 40mm.
I am not sure about the smaller ring I don't remember having that
but it's been a long time..
I use a drill press.
Put it between the chuck and the table, press it together,lock the drill press, and bolt it together. You can also use a large vice. Just put some wood under the seat or you will mar it.
I have a 20g with the Bullseye turbine housing on it. It's attached to the centersection with a snap ring (C-clip). I messed it up and am having a hard time locating one (waiting for an answerback from Bullseye).
Does anyone know of a local source for these large snap rings (ie...
HOOD VENT MOD.Tools used.
Air wizzer
D.A. sander
Air angle die-grinder with 3m roll-lock sanding discs.
Various body files (slap file and metal body file)
BONDO
Filler Primer
Sanding blocks
Harbor Freight Mini Tig.(NOT SHOWN)
22 GA sheet stock for side gussets...