And there was me thinking 1+1 is 2 lol, let me check the actual part number to be sure. I did just go by the big letters lol so if i pulled the buy faster then i should the whoopsie.
yup on the back it says 105c as I'm pretty sure i checked for that also. I'm not electronics expert but its crazy how much smaller it can be for the same product!
So I'm working on my 1g finally and ordered new exact OEM capacitors. Has tech come along way since as the OEM one is huge compared to the new one but its rated to the same spec? Check out the pics but its almost 4mm smaller but exactly the same specification. I know back from 90's etc things do...
Nah its just a fine like powder that burns on. I not noticed any smell from it. The ceramics tend to go red/brown vs staying while or light tan. Im not sureif i got my old plugs anymore but if i doni shall snap a pic.I have not opened up the system on my daily to see how far if any it goes...
I had a B&M. Long tru cooler. It worked but not aswell as i wanted. I had ducting also but i think a fan may of been helpful. I re did my setup using setrabs. No direct fans but the cooler does better. I seen many work but most do have fans on it
Actually decided and had time to work on this talon! Shocking...So over the last 2 weeks i have started to work on the main things and a clean up of parts.AT, the valve body came out as i wanted to install a shiftkit and change the fluids and filter anyway. Part of new ownership is going...
I had samples made and test fitted. I have now re tweeked some areas and need to make 1 new clip. They will be re checked on the tweeked ones and if all approved i will be looking at the next steps
The clips are very small and detailed, i have to hand draw every one from measurements. I do have a scanner but these parts are so small and some places really thin
I have 3D printed the prototypes. Tweeks can then be made to suit but the end goal would be to have them injection molded as i wish to adjust the material to a slightly better spec for one thats less brittle after some age and should be alot more reuseable as its an ABS blend vs pure ABS...
Thanks to a few sites for this. I found some on the Mirage forums also which might help someone one day find a specific ECU and where it came fromECU # Year Model Displacement Transmission Emissions Notes
MD005660 JDM/NZ ECU
MD081123 1985-1986 Pick Up 2.0l
MD102608 1987-1988 Pick Up 2.0l...