The Top DSM Community on the Web

For 1990-1999 Mitsubishi Eclipse, Eagle Talon, Plymouth Laser, and Galant VR-4 Owners. Log in to remove most ads.

Please Support RTM Racing
Please Support Rix Racing

Recent content by DynastyLCD

  1. DynastyLCD

    Sold SOLD! Please delete

    SOLD - please delete
  2. DynastyLCD

    Sold delete

    delete
  3. DynastyLCD

    Most embarrassing DSM moment?

    i was out with my girlfriend, pulled up at a stop sign behind my friend who has an old, beater Escort. he sees me in his rearview, and drops the clutch. so we start rippin up the hill, and i'm laughing because i keep letting off the gas to keep from hitting him. he signals for his driveway, i...
  4. DynastyLCD

    Quater master 7.25 v drive. Adjustent tips?

    my PTT does the same thing, with the chattering at idle. one thing i learned right away about twin disc's, is that you do not want to over-extend the pressure plate fingers. for that reason i use a pedal stop with mine, and have it adjusted so that it only goes far enough not to drag. otherwise...
  5. DynastyLCD

    brakes went from wet cardboard to getting thrown thru the window.

    did you swap the booster too? i've been running one in my DD, and i also put one in my other 1g as well! i kept the factory booster though. im curious if i should upgrade that as well.
  6. DynastyLCD

    Removing 7 bolt with automatic transmission

    it helps to use a prybar to keep the torque converter with the transmission, before you completely seperate the engine and transmission. try to keep the torque converter on the transmission as best as you can - it likes to spill a lot of fluid when you dont ;)
  7. DynastyLCD

    1G O2 problem!!

    It would be worth your while to check the wiring from the O2 sensor, to the ECU. Get a FSM for the electrical section, and an ohmmeter, and get to work!
  8. DynastyLCD

    bucks near WOT but no knock

    ^ This. I've had this same problem time and time again, with multiple DSM's... Only to change either the coil pack, or the transistor pack.
  9. DynastyLCD

    SCM61 Oiling

    awesome! i will be trying the .080" restrictor that i found here: Turbo Oil feed Flange 0.08" restrictor T3 T4 Very Flat | eBayi will try to remember to post back on my results, car should be running within the next month and a half or so!
  10. DynastyLCD

    SCM61 Oiling

    thank you Justin, you were the one i was hoping would respond to this!would i be better off buying something like this?EXTREME PSI : Your #1 Source for In Stock Performance Partsor should i go with something like the red FP filter/restrictor?thanks again for your feedback!edit: this...
  11. DynastyLCD

    SCM61 Oiling

    recently picked up an PTE SCM61 in a DSM bolt on housing. i did some searching, and came up with no results on oil feed specs. this is a journal bearing turbo, im curious as to how i should oil this thing. i figured that being a journal bearing turbo, that an OFH feed would work well. should i...
  12. DynastyLCD

    Reservoir Overflow Missing

    could have either a restriction somewhere in the cooling system, possibly a stuck thermostat, air pocket in the system... and on the bad end of things, a head gasket issue. start by bleeding out the cooling system again, make sure you purge all of the air out, and see if that helps you!also...
  13. DynastyLCD

    Which of these two fmic's are better?

    i got the opportunity to help a friend install a CXracing FMIC kit.a month or two later, i put on an ETS street core, which the CXracing kit is copying.honestly, i wish i had put his CXracing one on, then the ETS, and logged the two for IAT's to tell a difference. same everything, boost...
  14. DynastyLCD

    Master cylinder install gone wrong?!

    like bryan stated above, if the clutch pedal assembly has play, you need to rebuild it.this requires buying the clutch pedal parts, and its recommended to get a set of upgraded bushings as opposed to using mitsubishi parts.that can all be found here, except the bushings...
  15. DynastyLCD

    How did I do for my 1st attemp.

    lookin good so far, nice job with the bulkheads!
Support Vendors who Support the DSM Community
Boosted Fabrication ECM Tuning ExtremePSI Fuel Injector Clinic Innovation Products Jacks Transmissions JNZ Tuning Kiggly Racing Morrison Fabrications MyMitsubishiStore.com RixRacing RockAuto RTM Racing STM Tuned
Back
Top