Yea i have went to autozone and seen some that are close. I will probably just go with those. Because i have been searching everywhere for them. I just wasnt sure if there was a place online that have the same ones. But thank you for the quick response.
I have been searching and still havent found any real good answer. Im looking for the clips that pop the trim pieces on the outside of the doors and behind on the quarter panel. Mine are all broken and am getting my car painted soon and need to replace all of them. If anyone has any idea where...
I have my boost source from my j-pipe and then the other hose to my wastegate actuator, and i even flipped the lines around on the mbc. still the same. i guess i will try to adjust the rod and see what happens, ill keep u guys updated.
I recently just put a new evo3 16g on because my old one took a crap... and my manual boost controller does not work on my new setup. It worked great on my last 16g and held boost at 12psi and then i put it on the new one and its always wide open, no matter how i adjust it. Do i maybe have to...
i fixed it yesterday but the sensor still threw a code. so im sure the sensor is shot. and autozone and oreillys seem to have no clue about that sensor. they just know about the other two. one for the gauge and the one for the fan. And not the one for the ECU.
I pulled the couplers apart and re tightened them many times lol like 10 times still same.... the pipes all are in the couplers.. and i have the short route so there is only one pipe for each side... its got me stumped... Could that sensor and check engine code 21 have anything to do with it...
So i have some new info. a couple of days before i got my front mount installed my car would surge when coming to a stop light when idleing and then go away after 3 quick surges.. but i dint look into it then. i hooked my intercooler up and it was still there. i figured it was a boost leak.. i...
Hey i just put my new front mount on its the VR speed front mount. i put it on and now my car is sputtering out at about 4.5 rpms. it pulls hard until then. i changed the plugs out with ones i had already. i just put new plug wires on. i have a 16g but have just at 10 psi. until i get my...
i just went with the extreme psi kit... bought the greddy kevlar kit.. and in my opinion do the balance shaft eliminator kit... my balance shaft bearings are what made me tear mine apart and redo everything i spun the rear balance shaft bearing.. plus it wasnt that hard to do it. i did mine with...
I say go for it. I just did my first timing belt last weekend. plus i did the balance shaft eliminator kit too. so it made it alittle more tricky for my first time. but everything went really smooth because of all the info and tips on these boards :) started the car up and ran great i really...