4gfun
Supporting VIP
- 2,009
- 55
- Dec 10, 2007
-
Ask Me,
Virginia
I had the below head shipped by Dale Morss (BogusSVO) about 4 years and 4 months ago for a project that never happened. It sat on the project DSM's head with the valve cover on it and cling wrap over the top to stop crap from falling in. The head sits with cleaned up lifters, rockers, and everything listed below including a set of stock cams that I won't be using. I oiled everything up before letting it sit.
Specs:
Resurfaced 2g cylinder head with 3 angles on the seat + 2 angles on the valves, back cut valves, factory seats, and 6t valves, 1100 BC Springs, Viton Blue seals, oil port mod, and cc'd at 7.6:1
I am noticing rust spots in some areas....obviously not on the aluminum.
Can I use the head or do I need to do something else first? Wondering if I could use that fogging oil mentioned in my previous similar thread?
I'd hate to send this off to a do nothing machine shop around here that would love to charge me and make things worse.
Thanks for your time!
Specs:
Resurfaced 2g cylinder head with 3 angles on the seat + 2 angles on the valves, back cut valves, factory seats, and 6t valves, 1100 BC Springs, Viton Blue seals, oil port mod, and cc'd at 7.6:1
I am noticing rust spots in some areas....obviously not on the aluminum.
Can I use the head or do I need to do something else first? Wondering if I could use that fogging oil mentioned in my previous similar thread?
I'd hate to send this off to a do nothing machine shop around here that would love to charge me and make things worse.
Thanks for your time!