TheFlashDSM
Supporting Member
- 1,082
- 312
- Feb 18, 2010
-
stony brook,
New_York
i have a daily 96 auto gsx fully stock i have dsmlink v3 full in the car now to check whats wrong and i cant figure it out
start the car cold and goes to 750rpm and wont raise idle to warm up, im in long island ny and its cold right now, and for the life of me with all the research i cant figure this out! issue with my 2g dsm all options have been checked,
CEL FOR P0400 AND P0443 cant clear no matter what i do
-has fuel odor
-hot start dips low then comes up to idle at 750rpm
ecu checked for being burnt out (good) replaced with 2 other good ones i have here for a 96 gsx auto
eletrical connection cleaned and check for voltage (good)
MDP replaced and little hole was cleaned
tps in perfect sync and was replaced 3 times
replaced evap check valve and black cone plunger thingy
replaced and check ohm of all sensors and solenoids.
replaced coolant temp sensor
replaced, isc
replaced fiav
cleaned carb
no boost leaks, all vacuum lines are correct! (checked multiple times)
replaced maf
replaced egr
replaced fuel press reg.
im out of ideas and here is my log of idle for like 20 min, i was mainly setting the biss screw to 30 and learned idle adj to 144, am i missing a step after this?
I HAVE ALL SENSORS LOGGED PLEASE VIEW AND HELP ME
start the car cold and goes to 750rpm and wont raise idle to warm up, im in long island ny and its cold right now, and for the life of me with all the research i cant figure this out! issue with my 2g dsm all options have been checked,
CEL FOR P0400 AND P0443 cant clear no matter what i do
-has fuel odor
-hot start dips low then comes up to idle at 750rpm
ecu checked for being burnt out (good) replaced with 2 other good ones i have here for a 96 gsx auto
eletrical connection cleaned and check for voltage (good)
MDP replaced and little hole was cleaned
tps in perfect sync and was replaced 3 times
replaced evap check valve and black cone plunger thingy
replaced and check ohm of all sensors and solenoids.
replaced coolant temp sensor
replaced, isc
replaced fiav
cleaned carb
no boost leaks, all vacuum lines are correct! (checked multiple times)
replaced maf
replaced egr
replaced fuel press reg.
im out of ideas and here is my log of idle for like 20 min, i was mainly setting the biss screw to 30 and learned idle adj to 144, am i missing a step after this?
I HAVE ALL SENSORS LOGGED PLEASE VIEW AND HELP ME
Attachments
Last edited: