90 Coil on Plug

[thejollyrancher]

Hey,

I recently bought a COP setup on here which was advertised as a 1g setup but its set up for a 2g. The COP is wired up for a 2g triangle connector to the harness and has 3 wires. My 90 has a square connector with 4 wires. How do I set this up to make it work? I did some research but I just found dead links.

Thanks

 

[codym]

http://www.dsmtuners.com/forums/newbie-forum/469891-cop-wiring-90-cop-came-91-a.html

http://www.dsmtuners.com/forums/articles-electrical-wiring/290665-coil-plug-wiring-install-pics.html

 

[thejollyrancher]

The first link is exactly what I needed. Thanks

 

[brads]

There are places that sell that 4 pin connector, so you could modify the COP to make it plug in, before putting it on the car. You should be able to just depin the 3 pin connector, and put those into the 4 pin connector, then reuse the tach module off your original system.

Extreme PSI, JNZ, Magnus all sell that connector. Maybe a few other shops too.