Did you fix your fuel pump problem? I think my fuel pump is bad. Everytime i start my car it shuts down.

yeah i had the same problem with crower, it eventually stopped after a week or two and letting the ecu learn the new curve. I now have an afx computer which learned the curve quicker after i installed it. I cant remember if u mentioned it, but new springs also helped it idle smoother. If all else fails, you could adjust your throttle stopper, to make sure that air is always getting in, should help prevent it from dying.

thanks bro for everything it helped alot

ok so when i t the oil sending line on the back of the block do i cut the line and install the t is it a 3 way t two sides oil sensor line and the third the oil feed line ....or do i have to take out the sensor .....and at home depo were would i find this t and is it hard to make and expensive ...please let me know as soon as you can thanks bro

hey bro when you turbod your 420a were did you run your turbo oil feed line and were did run the coolent line i bin trying to figure out were to connect those lines and i got an idea but i want to make sure from sombody how has done it befor ill appreciate the help thanks

howed the tranny work out was it a 3.55

Go to superbrightleds.com, or get the flexible 96 led bar, take apart your headlight metal clips, then use a heat gun around the edges while prying it apart.theres a black plastic piece at the front inside, before taking it out, notice theres a 1/4 inch clearance at the bottom, thats where the lights will go, take out the black piece, put in the led strip face forward, bring it all the way across to the end, drill a small hole at the corner of the back headlight, so the wires stick out, glue it in place or use really strong 3m tape, put the black plastic piece back in and the rest of the headlight, then tap the positive wire to the parking light wire, then the negative to a ground, such as the blot that holds the headlight together. test it out before putting the headlight back together. then when putting the headlight back together put a thick clear adhesive around the edge and put it together and put the clips back it. let me know how it works bro.

Fierro