Today I finally had some time to work on the car and started testing components. Most components are fine such as CAS, spark plug wire, coilpack, power transistor, etc.

I have spark, fuel I think which is due to smelling like fuel after a few clicks, and air maybe?My MAF is fine maybe the connector?

Codes came up after like 10 cranks which are P0105,p0115,p0120.
...

Well I tried to start my project car and it doesn't start.

Cranks, has fuel, and timing should be good but it doesn't start. I think it doesn't have any spark but we'll see. It's a good thing that I have a spare dsm that I daily drive to test parts on my project. I'm going to see if the spark plug wires are still good and go from there.

Hopefully I'll get a chance...

Well its almost done.

All is left is to clean the car up, mount the new bumper, get some chicken fence, install the stiffer mounts, and coolant.

Oh! just found out that some of the valve cover bolt are stripped... well I suppose its time to get me some helicoil M6x1.0 and studs.

Oh Btw Happy Father's day!

So today, day before mother's day. I went over to my grandma's place where my car is located to work on my car some more and celebrate mother's day early.

Pretty much finished my interior wiring and now I'm working on soldering some of the engine wiring.

Was trying to solder some 14 gauge wire and... my soldering iron just couldn't handle it It just couldn't heat...

So today I solder as much wires as I can in the interior. Almost done

Here are a few pictures on the engine bay. Couldn't really take good ones because of creepy spiders lol





...