| Timeslip & Dyno Info |
|
|
| Bolt-on Modifications |
|
Fp3065 turbo , FP 3" O2 housing ,FP oil lines , FP water fittings , FP -4AN oil filter , 4" FP intake pipe with 12" K&N Air filter , Fp race manifold ceramic coated , 1g Magnus Intake Manifold , BOV 50mm tial , Wastegate 44mm tial , intercooler ETS pro race . Custom stainless steel ETS intercooler piping for FP3065 turbo , 1g Throttle body with FIAV block plate , oil filter relocation kit with -10 AN fittings , Buschur racing Coil On plug , Custom Valve cover with -10 AN fittings for oil catch can , Custom fuel system : Aeromive A1000 fuel pump , custom surger tank , all hoses and fittings on -10 AN size , Aeromotive A1000 Fuel pressure regulator , Custom fuel rail with 3 outputs ( 2 feed , 1 return ) , 880cc precision injectors , 100 micron aeromotive fuel filter , walbro 255 in tank , J
|
| Engine Management |
|
Microtech LTX-8 with complete custom wiring harness , Microtech Dashlogger shows ( boost , water temp , RPM , any problem ) , 3 bar map sensor , MSD DIS-2 high output with BR8EG spark plugs , HKS EVC V boost controller .
|
| Engine Internals |
|
Je pistons ( 8.5:1 ) , Manley rods , ACL bearins , FP2x Camshafts , Supertech dual valve springs and titanium retainers , 3 angle valve job, FP valve stem seals , 3g lifters , Full mitsubishi gaskets , Cometic head gasket , ARP main studs , ARP head studs , FP Balance shaft eliminator kit , FP 4g63 small kit .
|
| Drivetrain Modifications |
|
Act Flywheel , Clutchnet Red 3x 2800 lb with Kevlar/Kevlar disc .
|
| Parts Wishlist |
|
Stage 4 johny shepherd tranny with quaife LSD , Driveshaft stage 5 , Alky control meth/injecton , supertech custom valves , D2 2g racing coil over ,
Oil gauge, fuel gauge .
|
| Recommended DSM Shop |
|
Forced Performance
|
| Occupation |
|
Civil Engineer
|
| Other Interests |
|
Hot girls .
|
|
|
| Profile Photo |
|
| Contact Info |
|
|
| Participation Info |
|
|
|
