green97gstspyder
10+ Year Contributor
- 143
- 0
- Mar 14, 2012
-
newark,
Delaware
I have a question about my awd drivetrain I am going to put in my spyder. How do I know it's working properly before I install it? Most of the parts are removed but the engine and trans is still in the donor car. I thought if I spun one of the front wheels then the output of the x case should turn as well. Am I wrong? I would like to figure this out before I put all this in. I checked the rear lsd diff and both wheels spun forward so this is still working but just not sure about the front half. Thanks in advance.
Also when I spin the front tires the they spin in opposite directions if this means anything. The only time I can get the output on the x case to move is when the car is in neutral and I spin the front tires in gear it doesn't move. I also found out that if I rotate the input shaft of trans the output to x case will rotate as well. Hope this is enough info for everyone. I just want to make sure I'm not installing broken parts is all.
Also when I spin the front tires the they spin in opposite directions if this means anything. The only time I can get the output on the x case to move is when the car is in neutral and I spin the front tires in gear it doesn't move. I also found out that if I rotate the input shaft of trans the output to x case will rotate as well. Hope this is enough info for everyone. I just want to make sure I'm not installing broken parts is all.
Last edited: